Filter
Top Products
19. Output Source HP/LP/FULL Switch: Select the desired
crossover setting, HP/LP/FULL for the RCA output signal.
20. Output Crossover Freq. Control: Use this control to adjust the
output crossover frequency from 30Hz to4kHz.
21. Output Crossover HP/LP/FULL Switch: Select the desired
crossover setting, HP/LP/FULL for the internal output signal of the
RCA output.
Note: See the next section for the rear panel view of this endplate.
A1200/4 END PLATE DIAGRAM
1. Power/Ground
PowerLock
TM
: After you have securely
connected your power and ground wires, plug in the Power/Ground
PowerLock
TM
connector here.
2.
QBASS REMOTE
TM
: Plug in the data cable from the optional
QBASS REMOTE
TM
dash mounted level control here. (The remote
level control will bypass the amplifier’s on board
QBASS
TM
control.
3.
QBASS PLUS
TM
: Up to 18dB of bass level control boost.
4. Cooling Plenums: Maintain a minimum 2” clearance around
cooling plenums for proper amplifier cooling.
QBASS
REMOTE
QBASS
+18 0
1 2 3 4
19