Filter
Top Products
ENGLISH
Connections Setup Playback Setting the Timer Other Functions Troubleshooting Specifications
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
•
Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• Sufficiently ventilate the place of installation
If the unit is left in a room full of the smoke from cigarettes, etc., for
long periods of time, the surface of the optical pickup could get dirty,
in which case it will not be able to read the signals properly.
• About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
•
Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
b Note
b
b
Wall
b
q Music CDs
Discs marked with the logotype below can be played in this unit.
w CD-R/CD-RW
Discs Usable on the RCD-M37
1. High quality amplifier stressing sound quality
Equippd with 30 W + 30 W (6 Ω/ohms) high quality amplifier
circuits.
2. Tone control and SDB control
Separate bass and treble tone controls for adjusting the tone to your
tastes and Super Dynamic Bass (SDB) circuit for producing powerful
bass sound even when the volume is low.
Source direct position provided for turning off the SDB and tone
control circuitry to make the response flat.
3. CD player for digital sound
Compact body integrating a CD section in addition to the FM/AM
tuner and amplifier, allowing playback of CD-R/RW discs.
4. Playback of MP3 and WMA files
Supports playback of discs and USB memory devices on which MP3
and WMA files are recorded. The track name and artist name of the
currently playing track can be displayed on the set’s display.
The characters that can be displayed “Switching the Display”
(vpage 16)
5. Low standby power consumption
Designed with considerations on the environment, with the power
consumption when the power is in standby kept down to about 0.3 W.
Check that the following parts are supplied with the product.
q Remote control (RC-1097) .......................................................1
w R03/AAA batteries ...................................................................2
e Power cord (Cord length: Approx. 6.6 ft / 2 m) ........................1
r AM loop antenna .....................................................................1
t FM indoor antenna ..................................................................1
y Owner’s manual ......................................................................1
u Warranty (for North America model only) ................................1
i Service station list ................................................................... 1
Thank you for purchasing this DENON product. To ensure proper
operation, please read this owner’s manual carefully before using the
product.
After reading them, be sure to keep them for future reference.
Getting Started
q e r t
Getting Started
Accessories
Cautions on Handling
Cautions on Installation
Main Features
Discs