Filter
Top Products
6
ENGLISH
DVD/
VDP
DVD/ VDP
CDR/
TAPE
CDR/
TAPE
VCR
VCR
V. AUX V. AUX
VCR
VCR
MONITOR
IN IN
OUT
OUTIN
OUT
CD
R
L
R
L
R
L
PRE OUT
AUDIO VIDEO
ANTENNA TERMINALS
VIDEO
ROOM TO ROOM (REMOTE CONTROL)
SPEAKER SYSTEMS
AC OUTLETS
SPEAKER IMPEDANCE
A OR B / 4 16
A + B / 8 16
AC 120V 60Hz
SWITCHED
TOTAL 120W(1A.)
MAX.
R L R L
AB
FM
COAX.
75
AM
LOOP
ANT.
L
R
L
R
LINE IN
LINE OUT
LINE OUT
R
INPUTOUTPUT
LRL
L
R
L
R
L
R
R
OUTPUT
L
R
L
++
R
L
INPUT
OUTPUT
AUX OUT
DIGITAL AUDIODIGITAL AUDIO
5
CONNECTIONS
• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left
with left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• If hum or other noise is produced when the ground wire is
connected, disconnect it.
• Noise or humming may be generated if a connected
component is used independently without turning the power of
this unit on. If this happens, turn on the power of the this unit.
Connecting the audio components
Tape deck
CD player
Connecting a CD player
Connect the CD player’s analog output jacks (ANALOG
OUTPUT) to this unit’s CD jacks using pin plug cords.
AC 120 V, 60 Hz
AC OUTLETS
• SWITCHED (total capacity – 120 W (1 A.)
The power to this outlet is turned on and off in conjunction with the POWER operation
switch on the main unit, and when the power is switched between on and standby
from the remote control unit.
No power is supplied from these outlets when this unit’s power is at standby. Never
connect equipment whose total capacity is above 120 W (1 A.)
NOTE:
Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc.
Connecting the AC OUTLETS
Connecting a tape deck
Connections for recording:
Connect the tape deck’s recording input jacks
(LINE IN or REC) to this unit’s tape recording
(OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks
(LINE OUT or PB) to this unit’s tape playback
(IN) jacks using pin plug cords.
AC CORD
RC-617 (Sold Separately)
Infrared sensor
RC-616 (Sold Separately)
Infrared retransmitter
Another room
Use these jacks when using
another separate amplifier or a
pre-main amplifier.
PRE OUT jacks