Denon DCM-5001 Stereo System User Manual


 
ENGLISH
15
Page
CD cannot be played or no sound
is produced when connected in
daisy chain.
If a problem should arise, first check the following.
1. Are all connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase.
Symptom Cause Measures
LED not lit when power switch
set to on.
Power cord not plugged in securely. Check the insertion of the power cord plug.
Turn the power on with the remote control unit
after turning the POWER switch on.
9
Playback does not start in the
stand alone mode.
There are no discs in the disc rack.
Is the disc dirty or scratched ?
The mode switches are not properly set.
Insert a CD.
Wipe the dirt off the disc or replace the disc.
Check the mode switch setting.
8
14
10
There is no sound, or it is
distorted.
Is the output cord properly connected to the
amplifier ?
Have the amplifier controls been set correctly ?
Check the connections.
Adjust the amplifier’s controls.
9
A specific position of the disc
will not play.
Is the disc dirty or scratched ? Wipe the dirt off the disc or replace the disc. 14
No data is output from the digital
output jack.
Is the pin cord properly connected ? Check the connections. 9
Is the pin cord (Digital out, in) properly
connected?
Is the daisy chain control code properly
connected?
The mode switches are not properly set.
Check the connections.
Check the mode switch setting.
12
12, 13
TROUBLESHOOTING
9
ANALOG
No. of Channels: 2 Channels
Frequency Response: 2 ~ 20,000 Hz
Wow & Flutter: Below measurable limit: (
±
0.001 % W.peak)
Output Level: 2.0 V
Signal-to-noise Ratio: 100 dB
Harmonic Distortion: 0.008 % (1 kHz)
DIGITAL
Output: COAXIAL (0.5 V
P-P
75 /ohms)
DISCS Compact Disc format
GENERAL CHARACTERISTICS
Power Supply: AC 120 V, 60 Hz (for North America model)
Power Consumption: 42 W
Dimensions: 434 (W) x 243 (H) x 474.5 (D) mm (17-3/32”) x (9-9/16”) x (18-43/64”)
Weight: 16.2 kg (35 lbs 11 oz)
SPECIFICATIONS
10
HDCD
®
and High Definition Compatible Digital
®
are registered trademarks of Pacific Microsonics, Inc.
* Design and specifications are subject to change without notice in the course of product improvement.