Filter
Top Products
52
12
LISTENING TO THE RADIO
Auto tuning
1
Set the input function to “TUNER”.
INPUT SELECTOR
(Main unit) (Remote control unit)
2
Watching the display, press the BAND button to select the
desired band (AM or FM).
3
Press the MODE button to set the auto tuning mode.
“Auto” appears on the display.
4
Press the TUNING UP or DOWN button.
Automatic searching begins,
then stops when a station is
tuned in.
If tuning does not stop at the desired station, use to the “Manual
tuning” operation.
1 4
3
2
4
Manual tuning
1
Set the input function to “TUNER”.
INPUT SELECTOR
(Main unit) (Remote control unit)
2
Switch the remote control device to “TUNER”.
Watching the display, press the BAND button to select the
desired band (AM or FM).
3
Press the MODE button to set the manual tuning mode.
Check that the display’s “AUTO” indicator turns.
4
Press the TUNING UP or DOWN button to tune in the desired
station.
The frequency changes continuously when the button is held
in.
NOTES:
• When in the auto tuning mode on the FM band, the “STEREO” indicator lights on the display when a stereo broadcast is tuned in. At open
frequencies, the noise is muted and the “TUNED” and “STEREO” indicators turn off.
• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO” indicator turns off.
To operate the tuner by remote control, switch the remote control device to “TUNER”.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)