Filter
Top Products
31
Preset memory
1
2
3
456
789
+10
0
TV/
VCR
OFF
TV
CD
CDR/MD/ TAPE RECEIVER
VCR DBS/CABLE
SKIP
SKIP
ENTER
MEMORY
VOLUME
CHANNEL
+
-
+
-
VDP DVD
POWER
REMOTE CONTROL UNIT
RC-883
ON /
SOURCE
TUNER
VDP
VCR-1 VCR-2/V.AUX
DVD
TV/DBS
CDR/TAPE
PHONO
CD
SURROUND
INPUT
OUTPUT
TEST
TONE
SPEAKER
6.1 / 7.1
SURROUND
5CH / 7CH
ANALOG
EXT.INMODE
CALL 2
BACKLIGHT
CALL 1
STEREO
STEREO
DOLBY/DTS
SURROUND
DSP
SIMU.
DISPLAY
SYSTEM CALL
DIRECT
RETURN
SETUP
MENU
SHIFT
SURR.
PARA.
OSD
A/B
MUTING
BAND MODE
TUNING
TUNING
1
5
3, 4
2, 3, 4
1
2
3
4
ON /
SOURCE
OFF
ENTER
SHIFT
Press the power ON/SOURCE button and the OFF button at
the same time.
• “SET UP” appears on the remote control unit’s display.
Press the ENTER button.
After “SEL MODE” is displayed, the last selected mode is
set. Use the D and H cursor buttons to display the component
whose codes you want to store in the memory, then press
the ENTER button.
The display switches as shown below each time the D
and H cursor buttons are pressed.
Use the D and H cursor buttons to display “ENTER CODE” on
the remote control unit, then press the ENTER button.
The remote control unit’s display switches as follows each
time the D and H cursor buttons are pressed.
5
6
7
“OK” is displayed when the signals are registered and the
mode is terminated.
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
4-digit number) for the
manufacturer of the component
whose signals you want to store in
the memory.
To store the codes of another component in the memory,
repeat steps 1 to 6.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR........................................................................HITACHI
CD, MD, TAPE, CDR, VDP, DVD, DVD SETUP............DENON
DBS..............................................................................GENERAL INSTRUMENT
CABLE..........................................................................JERROLD
NOTES:
• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control
unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the
included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check.
By using the preset memory, the included remote control unit can be used to control other makes of video equipment. Note that this is not
possible for some models, however. In such cases, use the learning function (see page 34) to store the remote control signals in the remote
control unit’s memory.
See page 37 for instructions on resetting the data stored in the preset memory.
1
2
3
456
789
0
BAND MODE
TUNING
TUNING
ENTER
SHIFT
ENTER CODE
CODE NO
LEARN
SYS CALL
RESET
AUTO SEARCH
BAND MODE
TUNING
TUNING
ENTER
SHIFT
TV CD MD TAPE VCR
DVD VDP CABLE DBS VCR2