Filter
Top Products
24
ENGLISH
Auto tuning
1
Set the input source to “TUNER”.
2
Watching the display, press the BAND button to
select the desired band (AM or FM).
3
Press the MODE button to set the auto tuning
mode.
Lit
4
Press the TUNING UP or DOWN button.
• Automatic searching begins, then stops when
a station is tuned in.
NOTE:
• When in the auto tuning mode on the FM band, the
“STEREO” indicator lights on the display when a
stereo broadcast is tuned in. At open frequencies,
the noise is muted and the “TUNED” and “STEREO”
indicators turn off.
2 41
Manual tuning
1
Set the input source to “TUNER”.
3
Press the MODE button to set the manual tuning
mode.
Check that the display’s “AUTO” indicator turns
off.
2
Watching the display, press the BAND button to
select the desired band (AM or FM).
Press the TUNING UP or DOWN button to tune
in the desired station.
The frequency changes continuously when the
button is held in.
4
NOTE:
• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO” indicator
turns off.
(Remote control unit)
3
1
4
2
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
Preset stations
32
1, 4
3
2
Preparations:
Use the “Auto tuning” or “Manual tuning” operation
to tune in the station to be preset in the memory.
1
Press the MEMORY button.
(Remote control unit)
NOTE: Please make sure the “AUDIO” position
of the slide switch on the remote control
unit.
2
Press the SHIFT button and select the desired
memory block (A to E).
(Main unit) (Remote control unit)
3
Press the PRESET UP or DOWN button to select
the desired preset channel (1 to 8).
(Main unit) (Remote control unit)
4
Press the MEMORY button
again to store the station in
the preset memory.
(Remote control unit)
To preset other channels, repeat steps 1 to 4.
A total of 40 broadcast stations can be preset – 8
stations (channels 1 to 8) in each of blocks A to E.
Recalling preset stations
21
2
1
1
Watching the display, press the SHIFT button to
select the preset memory block.
NOTE: Please make sure the “AUDIO” position
of the slide switch on the remote control
unit.
(Main unit) (Remote control unit)
2
Watching the display, press the PRESET UP or
DOWN button to select the desired preset channel.
(Main unit) (Remote control unit)