Denon AVR-1082 Stereo System User Manual


 
16
ENGLISH
This button can be pressed at any time during the system setup process to complete the process.
After completing system setup
1
At the System Setup Menu, press the SYSTEM SETUP button.
The changed settings are entered and the on-screen display turns off.
SETUP
On-screen display signals
1
2
3
4
Signals input to the AVR-3802 On-screen display signal output
VIDEO signal input
jack (yellow)
S-video signal
input jack
VIDEO MONITOR OUT video
signal output jack (yellow)
S-video MONITOR OUT video
signal output jack
E
C
C
E
E
E
C
C
C
C
E
E
C
E
C
C
(
C
: Signal
E
:
No signal)(
C
: On-screen signals output
E
:
On-screen signals not output)
NOTES:
The on-screen display signals are not output from the color difference (component) video signal
MONITOR OUT jacks.
For 4 above, the on-screen display signals are output to the VIDEO MONITOR OUT video signal output
jack (yellow) if the monitor TV is not connected to the S-video MONITOR OUT video signal output jack.
B
Point the remote control unit at the remote sensor
on the main unit as shown on the diagram.
The remote control unit can be used from a straight
distance of approximately 7 meters from the main
unit, but this distance will be shorter if there are
obstacles in the way or if the remote control unit is
not pointed directly at the remote sensor.
The remote control unit can be operated at a
horizontal angle of up to 30 degrees with respect to
the remote sensor.
NOTES:
It may be difficult to operate the remote control
unit if the remote sensor is exposed to direct
sunlight or strong artificial light.
Do not press buttons on the main unit and remote
control unit simultaneously. Doing so may result in
malfunction.
Neon signs or other devices emitting pulse-type
noise nearby may result in malfunction, so keep
the set as far away from such devices as possible.
Approx. 7 m
30°
30°
Using the remote control unit
8
REMOTE CONTROL UNIT
The included remote control unit (RC-884) can be used to operate not only the AVR-3802 but other remote
control compatible DENON components as well. In addition, the memory contains the control signals for
other remote control units, so it can be used to operate non-Denon remote control compatible products.
Inserting the batteries
q Remove the remote control units rear cover.
w Set three R6P/AA batteries in the battery
compartment in the indicated direction.
e Put the rear cover back on.
Notes on Batteries
Use R6P/AA batteries in the remote control unit.
The batteries should be replaced with new ones
approximately once a year, though this depends on
the frequency of usage.
Even if less than a year has passed, replace the
batteries with new ones if the set does not operate
even when the remote control unit is operated
nearby the set. (The included battery is only for
verifying operation. Replace it with a new battery as
soon as possible.)
When inserting the batteries, be sure to do so in the
proper direction, following the and marks
in the battery compartment.
To prevent damage or leakage of battery fluid:
Do not use a new battery together with an old
one.
Do not use two different types of batteries.
Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
Remove the batteries from the remote control unit
when you do not plan to use it for an extended
period of time.
If the battery fluid should leak, carefully wipe the
fluid off the inside of the battery compartment and
insert new batteries.
When replacing the batteries, have the new
batteries ready and insert them as quickly as
possible.