Denon DCD-500AE CD Player User Manual


 
ENGLISH
ENGLISH
10
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
PageMeasures CauseSymptom
Disc tray does not open. • The power is not on. • Turn on the power. 7
“NO DISC” is displayed
even though a disc is loaded.
•The disc is not properly loaded. • Reload the disc. 2, 3
Disc is not played when play
button is pressed.
The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
No sound is produced or
sound is distorted.
The output cables are not properly
connected to the amplifier.
The amplifier’s function setting or
adjustments are not right.
Check the connections.
Check the amplifier’s function and
controls and adjust as necessary.
6
No digital signals are output. The connection cables are not
properly connected.
Check the connections. 6
Specific section of the disc
cannot be played properly.
The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
Programmed playback is not
possible.
The tracks have not been
programmed properly.
•Program properly. 8
A CD-R or CD-RW disc
cannot be played.
The disc has not been finalized.
The recording conditions are bad or
the quality of the disc itself it poor.
Finalize the disc then play it.
Use a properly recorded disc.
2
2
Set does not operate
properly when remote
control unit is operated.
The batteries are spent.
The remote control unit is too far
from the set.
Replace the batteries with new
ones.
•Move the remote control unit closer
to the set.
3
3
Troubleshooting
Others
¢ Audio performance
Analog output
Channels: 2 channels
Playable frequency range: 2 Hz ~ 20 kHz
S/N: 105 dB
Dynamic range: 98 dB
Harmonic distortion: 0.003 % (1 kHz)
Wow & flutter: Below measurable limits
Output level: 2.0 V (10 k/kohms)
Signal type: 16-bit linear PCM
Sampling frequency: 44.1 kHz
Usable discs: Compact Disc
Digital output
Optical: –15 ~ –21 dBm
Emission wavelength: 660 nm
¢ General
Power supply: AC 230 V, 50 Hz
Power consumption: 13 W
Maximum external dimensions: 434 (W) x 107 (H) x 279 (D) mm (including protruding parts)
Mass: 4.0 kg
¢ Remote control unit (RC-1028)
Remote control type: Infrared pulse
Batteries: R03/AAA Type (two batteries)
External dimensions: 49 (W) x 220 (H) x 21 (D) mm
Mass: 106 g (included batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
“00 00 : 00” is displayed
even though a disc is loaded.
The loaded disc is not a CD. • Load a CD. 2