Filter
Top Products
ENGLISH
Operation
Opening and closing the disc holder and
loading discs
1
Press the POWER switch to turn on the power.
2
Press the
55
button.
• Pick up the disc carefully so as not to touch the
signal surface and hold it with the labeled side facing
up.
•With the disc holder fully open, set the disc in the
disc holder.
• Set 12 cm discs in the outer disc guide, 8 cm discs
in the inner disc guide.
3
Press the
55
button.
The disc is automatically loaded.
NOTE:
• If your finger should get caught in the disc holder when it
closes, press the
5 button.
The disc holder closes automatically if the 1/ 3 button
is pressed.
POWER
SUPER AUDIO CD
SET UP
1 2 3
4 5 6
7 8 9
+10+10
CLEARCLEAR
0
CALLCALLDIRECTDIRECT PROGRAMPROGRAM
TIMETIME
SUPERSUPER
AUDIO CDAUDIO CD
SETUPSETUP
DISPLADISPLAY
ARTISTARTISTTITLETITLE
REPEAREPEATRANDOMRANDOM
OPEN / CLOSEOPEN / CLOSE
RC-997
OPEN/CLOSE
NUMBER
SUPER AUDIO CD
SETUP
+10
Normal playback
• The layer for top priority playback after the disc is loaded can be set.
• The layer set for top priority playback upon shipment from the factory (default setting) is the Super Audio CD (stereo) layer.
Setting the top priority playback layer for
Super Audio CDs
1
Press the POWER switch to turn on the power.
2
Check that no disc is loaded.
3
Press the SUPER AUDIO CD SETUP button and
switch to the layer you want to set.
If the layer is switched while the disc is being loaded,
the playback layer switches for that disc, but the top
priority playback layer setting itself does not change.
When a disc is loaded after the setting has been made,
the contents recorded on the set layer are displayed.
If a disc that does not contain the layer set for top
priority playback is loaded, the contents recorded on
another layer are displayed automatically.
This setting is stored in the memory and is not cleared
even when the disc holder is opened or closed or the
power is turned off. To change the setting, repeat the
procedure above.
Outer disc guide
12cm disc
Disc holder
7
ENGLISH