Filter
Top Products
36
Speakers
Setting items Setting details
Set Defaults
The “Levels” settings are
returned to the default
settings.
Yes : Reset to the defaults.
No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER, the “Return settings to the default?”
prompt is displayed. Select either “Yes” or
“No”, and press ENTER.
BACK SETUP
ENTER
Crossovers
Default settings are underlined.
Set the maximum frequency of the bass signal output from each channel to the subwoofer.
Set the Crossover Frequency to suit the bass reproduction capability of the speaker being used.
Setting items Setting details
Front / Center / Surround
Select speaker for setting of
crossover frequency.
40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
•“Crossovers” can be set when the “Bass” – “SW Mode” (vpage36)
setting is “LFE+Main”, or when you have a speaker that is set to
“Small”.
•The default crossover frequency is “80Hz”, which will work best with the
widest variety of speakers. When using very small speakers, however,
you can choose a higher setting based on the specified frequency
response of the speakers. If the speaker has a specified frequency
response of 120 Hz – 20 kHz (as an example), then choose the 120 Hz
crossover frequency.
•For speakers set to “Small”, low frequency content below the crossover
frequency is attenuated to the speakers and the low bass content is then
re-delivered to the subwoofer(s), or the front (L/R) speakers if they have
been set to Large.
Bass
Default settings are underlined.
Set subwoofer and LFE signal range playback.
Setting items Setting details
LPF for LFE
Set LFE signal playback
range. Set this when you
want to change the playback
frequency (low pass filter
point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz : Set LFE
signal range playback.
SW Mode
Select low range signals
to be reproduced by
subwoofer.
LFE : The low range signal of the channel set to “Small” speaker size is
added to the LFE signal output from the subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best setting for most
systems.
•“SW Mode” can be set when “Speaker Config.” – “Subwoofer”
(vpage35) is set to other than “No”.
•Play music or a movie source and select the mode offering the strongest
bass.
•Select “LFE+Main” if you want the bass signals to always be produced
from the subwoofer.
NOTE
If “Front” and “Center” for “Speaker Config.” are set to “Large”, and
“SW Mode” is set to “LPF for LFE”, no sound may be output from the
subwoofers, depending on the input signal or selected surround mode.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD