Filter
Top Products
Multi-zone Operations
Turning the Power On and Off
GOperation on the main unitH
q Press <ZONE2 ON/OFF>.
w When the power turns on, the multi-zone indicator ( ) lights on
the display.
GOperation on the remote control unitH
q Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
w Press [ZONE2 ON] or [ZONE2 OFF].
Selecting the Input Source
GOperation on the main unitH
q Press <ZONE2 / REC SELECT>.
w Turn <SOURCE SELECT> and select the ZONE2’s input source.
GOperation on the remote control unitH
q Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
w Press [SOURCE SELECT].
Adjusting the Volume
GOperation on the main unitH
q Press <ZONE2 / REC SELECT>.
w Turn <VOLUME> to adjust.
GOperation on the remote control unitH
q Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
w Press [VOLUME].
– – –
–70dB
~
–40dB
~
+18dB[Variable range]
The volume can be adjusted when menu “Manual Setup” – “Zone2
Setup” – “Volume Level” is set to “VAR”. The volume can be increased
up to the value set at menu “Manual Setup” – “Zone2 Setup” –
“Volume Limit” (vpage 30).
SOURCE SELECT
<ZONE2 ON/OFF>
VOLUME
<ZONE2/REC SELECT>
SOURCE
SELECT
VOLUME
[MUTING]
[MODE
SELECTOR 1]
[MODE
SELECTOR 2]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Turning off the Sound Temporarily
q Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
w Press [MUTING].
The sound is reduced to the level set at menu “Manual Setup” –
“Zone2 Setup” – “Mute Level” (vpage 30).
To cancel, either adjust the volume or press [MUTING] again.
The setting is canceled when the zone’s power is turned off.
The source selected for ZONE2 is also output from the recording
output connectors.
NOTE
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2, playback is
only possible if the digital signal being input is in PCM (2-channel)
format.
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 audio output connectors.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
[MAIN OFF]
[ZONE2 ON]
SOURCE
SELECT
[ZONE2 OFF]
[MAIN ON]
When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing [MAIN ON] or [MAIN OFF].
1.AVR988EU_101_4th.indd 61 2007/09/13 11:32:53