Filter
Top Products
h
Trigger Out
Select the conditions to turn on the trigger out with respect to the
zone, input source, surround mode. For details about the trigger
out function, see page 19.
Setting with Respect to the Zone
• When the power of the zone turned on/off, the trigger out turns on.
• Associated with the power supply of zones set to “ON”.
Setting with Respect to the Input Source
• When the input source set to on is selected, the trigger out turns
on.
• Associated with respect to the input source for zones set to “ON” at
“Setting with Respect to the Zone”.
Setting with Respect to the Surround Mode
• When the surround mode set to on is selected, the trigger out turns
on.
• Associated with respect to surround modes that are set to “ON”.
• This can be set if the “MAIN ZONE” setting at “Setting with Respect
to the Zone” is set to “ON”.
• Associated when an input source for which “Setting with Respect to
the Input Source” is set to “ON” is selected.
j
Remote ID Setup
Set remote control ID.
k
2Way Remote
Make setting for 2-way remote control unit.
[Selectable items]
1
2
3
4
[Selectable items]
Used
: Use 2-way remote control.
Not Used
: Do not use 2-way remote control.
When using a 2-way remote control unit (RC-7000CI and RC-7001RCI,
sold separately), set this to “Used”.
l
Display
Adjust display brightness of the receiver.
Operating from the main unit
Press the DIMMER button.
Bright Dim
DarkOFF
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
[Selectable items]
ON
: Activate trigger on this mode.
– – –
: Do not activate trigger on this mode.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
A0
Setup Lock
Protect settings from inadvertent change.
• When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.
⋅ Menu operations
⋅ RESTORER
⋅ Night Mode
⋅ Parameter
⋅ Room EQ
⋅ Channel Level
⋅ Audio Delay
• To cancel the setting, press the MENU button to re-display the “Setup
Lock” screen, then change the setting to “OFF”.
[Selectable items]
ON
: Turn protection on.
OFF
: Turn protection off.
NOTE
When using the AVR-988 with only the included remote control unit
(RC-1069), there is no need to make settings.
When using a separately sold remote control unit (RC-7000CI, etc.),
this function can be used. Match the ID setting of the remote control
unit and the receiver.
Select “Trigger Out 1” or “Trigger Out 2” and make the settings below
respectively.
1.AVR988EU_101_4th.indd 35 2007/09/13 11:32:21