Filter
Top Products
ENGLISH
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
• To cancel, press <ZONE2/REC SELECT>, then turn <SOURCE SELECT>
until “ZONE2 SOURCE” is displayed.
• Make a test recording before starting the actual recording.
• Sources selected with the REC OUT mode are output from ZONE2
as well.
• In the REC OUT mode, the remote control unit’s ZONE2 mode
buttons cannot be operated.
• The “XM” digital audio output signals are not output from the
OPTICAL2 or OPTICAL3 output connectors.
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Input sources for which “Delete” is selected at “Source Delete”
cannot be selected.
Recording on an External Device
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <ZONE2/REC SELECT>.
“ZONE2 SOURCE” is shown on the display.
ZONE2 SOURCE ZONE2 TUNER ZONE2 XM····
RECOUT XM RECOUT TUNER RECOUT SOURCE······
2
Turn <SOURCE SELECT> until “RECOUT SOURCE”
is displayed.
The “ ” indicator lights.
3
Turn <SOURCE SELECT> to choose the input source
to be recorded.
4
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
44).
5
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
Other Operations and
Functions
Other Operations
Convenient Functions
1
Press <ENTER> or [CH SELECT].
Channel Volume
FL 0.0
dB
SR 0.0
dB
C 0.0
dB
SBR 0.0
dB
FR 0.0
dB
SBL 0.0
dB
SW 0.0
dB
SL 0.0
dB
Fader
FRONT : REAR
2
Use ui, <ENTER> or [CH SELECT] to select the
speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b “OFF” can be set by pressing o when the subwoofer’s volume is
set to –12 dB.
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
Press <ENTER> or [CH SELECT].
2
Press ui, <ENTER> or [CH SELECT] to select
“Fader”.
3
Use o p to adjust the volume of the speakers.
(o: front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
Fader Function
This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1.AVR888E3_ENG_1st.indd 51 2007/07/18 21:53:36