Filter
Top Products
ENGLISH
Subwoofer Mode
Select low range signal to be reproduced by subwoofer.
[Selectable items]
LFE
LFE+Main
: Select subwoofer signal.
Crossover
Select crossover frequency from which subwoofer handles low range
signal.
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz
: Select crossover frequency.
Distance FL
Set distance from listening position to front left speaker.
[Variable range]
0.0ft ~ 60.0ft
Distance FR
Set distance from listening position to front right speaker.
[Variable range]
0.0ft ~ 60.0ft
d
Dolby Digital Setup
Set dynamic range for downmix playback of Dolby Digital
sources.
• Set this to “ON” if the sound from the front speakers seems
distorted.
• When not using the center speaker or surround speakers, the
playback sound is down-mixed and output from the front speakers.
[Selectable items]
ON
: Compression is used. Select this if sound from front
speakers is distorted.
OFF
: Do not use compression. This is the recommended setting.
f
Auto Surround Mode
Make setting for memorizing surround mode setting for each input
signal type.
• The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals
listed below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r Multi-channel signals other than Dolby Digital and DTS (PCM,
etc.)
• When playing in the PURE DIRECT mode, the surround mode does
not change even if the input signal is changed.
[Selectable items]
ON
: Memorize settings. Most recently stored surround mode is
automatically selected.
OFF
: Do not memorize settings. Surround mode does not change
according to input signal.
Front
Select front speaker size.
[Selectable items]
Large
Small
: Select front speaker size.
Subwoofer
Select subwoofer use.
[Selectable items]
Yes
No
: Select subwoofer use.
g
Manual EQ
Adjust tonal quality for each speaker using graphic equalizer.
Base Curve Copy
Copy the Room EQ´s “Audyssey Flat” correction curve.
[Selectable items]
Yes
No
“Base Curve Copy” is displayed after the auto setup procedure has
been performed.
Adjust CH
Select speaker adjustment method.
[Selectable items]
Each CH
: Adjust tonal quality for each speaker separately.
L/R CH
: Adjust tonal quality for each L/R speaker pair.
ALL CH
: Adjust tonal quality for all speakers together.
Default
Resets the settings to the default values.
Manual EQ
Select the speaker and frequency band and adjust the level.
[Selectable items]
63Hz
125Hz
250Hz
500Hz
1kHz
2kHz
4kHz
8kHz
16kHz
[Variable range]
–20dB ~ +6dB
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
1.AVR888E3_ENG_1st.indd 32 2007/07/18 21:53:15