Filter
Top Products
Recording on an External Device
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <REC SELECT> until “RECOUT” appears on
the display.
2
Turn <SOURCE SELECT> to choose the input source
to be recorded.
The “REC” indicator and the indicator for the selected source
light.
3
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
30).
4
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
Other Operations and
Functions
Other Operations
Convenient Functions
1
Press <ENTER> or [CH SELECT].
FL Vol.+ 1.5dB
2
Use ui, <ENTER> or [CH SELECT] to select the
speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b “OFF” can be set by pressing o when the subwoofer’s volume is
set to –12 dB.
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
<SOURCE SELECT>
<SPEAKER A>
<SPEAKER B>
<ENTER>, op
ui
<REC SELECT>
<QUICK SELECT><POWER>
uiop
[CH SELECT]
uiop
[Front]
[Rear]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Playback
• To cancel, press <REC SELECT>, then turn <SOURCE SELECT> until
“RECOUT SOURCE” is displayed.
• Make a test recording before starting the actual recording.
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Digital signals are not output from the REC OUT (CDR/TAPE and
VCR) connector.
Getting Started Connections Setup Remote Control Information Troubleshooting
ENGLISH