Filter
Top Products
Setup
A2 Crossover Frequency
Select crossover frequency from which subwoofer handles low
range signal.
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
Q
12Cr.Over 80Hz
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz
:
Only the portion of the bass sound of the various speakers output
from the subwoofer that has a frequency below the frequency set
here is output.
Set this according to the low frequency reproduction capabilities of the
speakers you are using.
• The “Crossover Frequency” can be set when there are speakers that
have been set to “Small” at “System Setup” – “Speaker Setup” or
when “Subwoofer” is set to “Yes” (vpage 20).
• For speakers set to “Small”, sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• Always set the crossover frequency to “80Hz”. When using small
speakers, however, we recommend setting the crossover frequency
to a higher frequency.
A3 Test Tone
Adjust channel levels to obtain equal volume from all speakers.
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
Q
13 T.Tone Yes<
Q
T.Tone Auto >
Q
Test Tone On
Q
Auto-FL
Test Tone
Select test tone playback method.
[Selectable items]
Auto
: Automatically switch speaker from which test tone is
output.
Manual
: Manually switch speaker from which test tone is output.
Test Tone Start
Press the o button to select “Yes”, then press the o p button to select
“Auto” or “Manual”.
Then press the i button. Out put the test tone.
Auto : Press the o p button to adjust the volume.
Manual : Press the u i button to select the speaker, then press the
o p button to adjust the volume.
When the adjustments are completed, press the ENTER button to
finish the test tone.
[Variable range]
–12dB
~
0dB
~
+12dB
• Speakers set to “None” in the Speaker Configuration settings are not
displayed.
• When “Channel Level” is adjusted, the adjusted values are set for
all the surround modes. To adjust the channel level separately for the
different surround modes, use the operation see page 35.
Operating from the remote control unit
Adjusting with the remote control unit using the test tones is only
possible in the “Auto” mode and only effective in the STANDARD
mode. The adjusted levels for the different modes are automatically
stored in the memory.
GAdjusting using test tonesH
q Press the TEST button.
Test tones are output from the various speakers.
w Use the o p button to adjust so that the volume is equal for all
speakers.
e When the adjustments are completed, press the TEST button
again.
Operations (vpage 19)
Getting Started Connections Playback Remote Control Information Troubleshooting
ENGLISH