Filter
Top Products
96
HDMI control function
If the HDMI control function does not operate properly, check the
following points.
•Is the TV or player compatible with the HDMI control function?
•Is “HDMI Control” (vpage121) set to “On”?
•Is “Power Off Control” (vpage121) set to “All” or “Video”?
•Is “Control Monitor” (vpage 121) set for the monitor output
connected to television?
•Is “Control Monitor” (vpage 121) set to the TV that uses the
HDMI control function when this unit is connected to two TVs that
support HDMI connectors?
•Are the HDMI control function settings of all devices correct?
NOTE
•When “HDMI Control” is set to “On”, it consumes more standby
power.
•The HDMI control function controls operations of a TV that is
compatible with the HDMI control function. Make sure that the TV
and HDMI are connected when you perform HDMI control.
•Some functions may not operate depending on the connected TV
or player. Check the owner’s manual of each device for details
beforehand.
•When “Power Off Control” on the menu is set to “Off”
(vpage121), this unit is not set to standby even if the connected
device is in the standby mode.
•When connection changes are implemented, such as adding
connections to HDMI devices, linked operations may be initialized.
In this case, you will need to reconfigure the settings.
•When “HDMI Control” is set to “On”, it is not possible to assign an
HDMI connector to “TV AUDIO” at “Input Assign” (vpage125).
•Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat steps 2 and 3.
•“Input Assign” – “HDMI” (vpage125) setting has changed.
•“Video Output” (vpage120) setting is changed.
•There is a change to the connection between the devices and the
HDMI, or an increase in devices.
•The HDMI ZONE2 function is not compatible with the HDMI control
function.
•When the HDMI ZONE2 function is used with “HDMI Control” in the
menu set to “On”, the HDMI ZONE2 function may not fully work.
•If “HDMI Control” in the menu is set to “On” and the power of
ZONE2 is on, this units may behave as follows. It is recommended
to disable the HDMI control function on your TV and player when
using the HDMI ZONE2 function. (Some example behaviors are
listed below.)
•When the power of the TV used for MAIN ZONE is off and the
player selected for ZONE2 starts playback, the TV used for MAIN
ZONE is turned on. In this case, the input source selected for MAIN
ZONE changes to the input source selected for ZONE2.
•When playing back a TV used for MAIN ZONE and ZONE2 with
an HDMI connection, turning off the TV used for MAIN ZONE also
turns off this unit and the player.
•When a same input source is selected for MAIN ZONE and ZONE2,
stopping playback of the player on the TV stops the playback on the
player and the video being played back in ZONE2 as well.
Basic version
Advanced version
Informations
Advanced version
DVD