Denon AVR-2310CI Home Theater System User Manual


 
3
Getting Started Connections Playback Remote Control Information Troubleshooting Specifications
ENGLISH
Multi-Zone
Making detailed settings (Manual Setup)
Setting items Setting contents
Trigger Out
Select the condition for
activating Trigger Out for
the input source, surround
mode, etc.
See “TRIGGER OUT jacks”
(vpage 19) for more
information on trigger out.
When Setting for Zone (MAIN ZONE / ZONE2)
Trigger out is activated through linkage to the power of the zone set to
“ON”.
When Setting for Input Source
Activate trigger out when the input source set to “ON” is selected.
Valid for the zone set to “ON” with “When Setting for Zone”.
When Setting for Surround Mode
Activate trigger out when the surround mode set to “ON” is selected.
Valid when the “MAIN ZONE” set to “ON” with “When Setting
for Zone” is selected, and when the input source set to “ON” with
“When Setting for Input Source” is selected.
n
n
n
Remote ID
Set when you operate
another DENON AV amplifier
with the remote control unit
of the AVR-2310CI. Match
the remote control unit you
are using with the remote ID
of the AVR-2310CI.
1 / 2 / 3 / 4
When using the AVR-2310CI with only the included remote control unit
(RC-1117), use Remote ID “1” (default).
When using a separately sold remote control unit (RC-7000CI, etc.),
this function can be used. Match the ID setting of the remote control
unit and the receiver.
232C Port
Set when using an external
controller or two-way remote
control connected to the RS-
232C terminal.
Serial Control : Set when using an external controller.
2Way Remote : Set when using a 2-way remote control unit.
When using a DENON two-way remote control (RC-7000CI or RC-
7001RCI, sold separately), set to “2Way Remote”.
NOTE
When setting to “2Way Remote”, you can not use the RS-232C connector
as an external controller.
Dimmer
Adjust display brightness of
the receiver.
Bright : Normal display brightness.
Dim : Reduced display brightness.
Dark : Very low display brightness.
OFF : Turns the display off.
Switching is also possible by pressing on the main unit.
Setup Lock
Protect settings from
inadvertent change.
ON : Turn protection on.
OFF : Turn protection off.
When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related settings.
RESTORER Dynamic Volume
MultEQ Channel Level
Dynamic EQ Audio Delay
: Moves the cursor (Up/Down/Left/Right)
: Decision the setting
: Return to previous menu
Remote control
operation buttons
:
Displaying the menu
Cancel the menu
Settings