Denon AVR-2310CI Home Theater System User Manual


 
9
ENGLISH
Getting Started Connections Playback Remote Control Information Troubleshooting SpecificationsMulti-ZoneSettings
Connecting Devices not Equipped with HDMI terminals
Connections
REMOTE CONTROL jacksn
"69
065
External Controller
RS-232C connector
When you connect an external control device, you can control
the AVR-2310CI with the external control device. Perform
the operation below beforehand.
q Turn on the AVR-2310CI’s power.
w Turn off the AVR-2310CI’s power from the external
controller.
e Check that the AVR-2310CI is in the standby mode.
n
When using the AVR-2310CI in combination with the DENON RF
remote controller (RC-7000CI, sold separately) or RF remote receiver
(RC-7001RCI, sold separately), two-way communication is enabled.
The AVR-2310CI’s status information as well as iPod and Internet audio
music files can be browsed watching the RF Remote Controller’s
display. For details, refer to the operating instructions of the respective
devices.
TRIGGER OUT jacks
The TRIGGER OUT output terminal outputs a maximum 12
V/150 mA electrical signal. When a device with TRIGGER IN
terminal is connected via a monaural mini-plug, the connected
device’s power on/standby can be controlled through linked
operation to the AVR-2310CI.
n
Set this to use the RS-232C connector for the DENON RF remote
controller.
“232C Port” (vpage 35)
Set as Necessary
Set to change the conditions for linked operation via the TRIGGER
OUT terminal.
“Trigger Out” (vpage 35)
Set as Necessary
NOTE
On the GUI menu, when setting “232C Port” to “2Way Remote”, you
cannot use the RS-232C connector as an external controller (vpage
35).
Extension jack for future use.
(Connect devices corresponding
with room to room function to
this jack.)
Infrared
retransmitter
Input
Output
Infrared
sensor
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlets to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Wait until all connections have been completed before connecting the
power cord.
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
Connection to the AC outlets
• These outlets supply power to external au-
dio equipment.
• Audio equipment with a total power con-
sumption of 120 W (1 A) can be connect-
ed.
• The power supply turns on and off together
with the on the main unit. When set
to “ON”, power is supplied from the outlet.
When set to “STANDB�”, no power is sup-
plied.
NOTE
When “HDMI Control” (vpage 31) is set
to “ON”, power is supplied constantly to
the AC outlet (UNSWITCHED).
Connecting the Power Cord