Filter
Top Products
Parameter
[AUDIO DELAY]
[NIGHT]
MULTEQ
RESTORER
DYNAMIC
VOLUME
[SOURCE
CONTROL 1]
uiop
ENTER
ENTER, opRETURNDYNAMIC VOLUME
uiMULTEQ <MENU>RESTORER
uiop
[STD]
RETURN
[MUSIC]
[CINEMA]
[A. MENU]
ENTER
[Front]
[Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
1
Press <MENU> or [A.MENU].
The menu is displayed.
b To operate from the remote control unit, be sure to set the
[SOURCE CONTROL 1] to “AUDIO”.
2
Press ui to select “Parameter”, then press ENTER.
3
To change the setting:
Press ui to select the item you want to change, then
press o p to change the setting.
b To return to the previous item, press RETURN.
b Select “Default Yes”, then press o to reset to the default
setting.
4
Press ENTER to enter the setting.
Adjusting the parameters
n To exit adjustment
Press <MENU> or [A.MENU] during adjustment.
Operating from the main unit
Use <SELECT/ENTER> to select the surround mode.
n During PCM (2ch) / Analog / DOLBY DIGITAL (2ch)
DIRECT STEREO
DTS NEO:6
7CH STEREO (5CH STEREO)
MATRIXVIRTUAL
DOLBY PRO LOGIC gx
(DOLBY PRO LOGIC g)
VIDEO GAME
MONO MOVIE
ROCK ARENA
JAZZ CLUB
n During Digital (Multi channel)
DIRECT STEREO
7CH STEREO
(5CH STEREO)
STANDARD
(Dolby Digital, DTS, etc)
MATRIXVIRTUAL
ROCK ARENA
JAZZ CLUB
MONO MOVIE
VIDEO GAME
Playback in the PURE DIRECT Mode
This is the mode that recreates the original sound most faithfully,
providing extremely high quality sound.
• To cancel, press [PURE] again.
• When in the PURE DIRECT mode, the on-screen display is not
displayed and the display on the main unit is turned off.
• If the HDMI input connector is selected, video outputs are output in
the PURE DIRECT mode.
• The channel level and surround parameters in the PURE DIRECT
mode are the same as in the DIRECT mode.
Press [PURE].
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Specifications