Denon AVR-1306 Stereo Receiver User Manual


 
ENGLISH
19
Basic Operation Basic Operation
ENGLISH
2 Input mode display
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
Depending on the input signal.
2 Input signal display
DOLBY DIGITAL
DTS
PCM
The “DIGITAL” indicator lights
when digital signals are being input
properly. If the “DIGITAL” indicator
does not light, check whether the
Digital In Assignment setup (
page 15) and connections are correct
and whether the component’s
power is turned on.
NOTE:
The “DIGITAL” indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will
be heard.
Playing audio sources (CDs and DVDs)
2-channel playback modes
The AVR-1306 is equipped with 2-channel playback modes
exclusively for music.
Select the mode to suit your tastes.
Press the DIRECT/STEREO button on the main unit
or the DIRECT button on the remote control unit to
select the DIRECT mode.
2 DIRECT mode
Use this mode to achieve good quality 2-channel sound while
watching images. In this mode, the audio signals bypass such
circuits as the tone circuit and are transmitted directly, resulting
in good quality sound.
Press the DIRECT/STEREO button on the main unit
or the STEREO button on the remote control unit to
select the STEREO mode.
2 STEREO mode
Use this mode to adjust the tone and achieve the desired sound
while watching images.
Surround
SELECT
DIRECT/STEREO
SURROUND PARAMETER
STANDARD
ENTER
STANDARD
DIRECT
SURROUND
PARAMETER
CURSOR
F
CURSOR G
STEREO
Dolby Pro Logic
II
mode
1
Press the STANDARD button to select the Dolby
Pro Logic II mode.
The Dolby Pro Logic II indicator lights.
Lights
2
Play a program source.
For operating instructions, refer to the manuals of the
respective components.
The mode switches as shown below each time the button
is pressed.
DTS NEO:6DOLBY PLII
3
Press the SURROUND PARAMETER button to
select the surround parameter mode.