Filter
Top Products
CE 4000
Power Amplifi er
Operation Manual
page 6
3 Setup
Figure 3.2 Airfl ow
Figure 3.1 Dimensions
3.3 Ensure Proper Cooling
When using an equipment rack, mount units
directly on top of each other. Close any open
spaces in rack with blank panels. DO NOT
block front or rear air vents.
Figure 3.2 illustrates standard amplifier air-
flow.
3.1 Unpack Your Amplifi er
YOU WILL NEED (not supplied):
• Two input wiring cables
• Two output wiring cables
• Rack for mounting amplifi er (or a stable
surface for stacking)
WARNING: Before you start to set up
your amplifi er, make sure you read and
observe the Important Safety Instruc-
tions found at the beginning of this
manual.
3.2 Install Your Amplifi er
CAUTION: Before you begin, make sure
your amplifi er is disconnected from the
power source, with power switch in the
“off” position and all level controls
turned completely down (counterclock-
wise).
Use a standard 19-inch (48.3 cm) equipment
rack. See Figure 3.1 for amplifi er dimensions.
You may also stack amps without using a
cabinet.
NOTE: When transporting, amplifi ers should be
supported at both front and back.