Filter
Top Products
Commercial Audio Series Business Music System
page 12
Operation Manual
2.8 Remote Volume Control
You can control the volume of each amplifier channel remotely. To do so,
locate the OUTPUT VCA connector on the back panel. Insert a 4-pin
Phoenix-type cable connector into the OUTPUT VCA connector. Wire a
Crown 1-VCAP or 4-VCAP level control to the Phoenix-type cable con-
nector terminals as shown in Figure 2.12.
1-VCAP controls one channel; 4-VCAP controls up to four channels.
2.9 Mounting the Speakers (180MAx Pack Only)
JBL supplies a variety of wall mounts and ceiling mounts for the Control
1ST loudspeaker:
• MTC-1A Wall/Ceiling Mount (included with 180MAx Pack)
• MTC-2 Plus Wall/Ceiling Mount
• TC-7 American Microphone Stand Adapter
• MTC-8 Wall Mount Bracket
For details, see http://www.jblpro.com/pages/recording/con-
trol.htm#Control1.
Figure 2.12 Wiring a 1-VCAP or 4-VCAP Level Control to the Output VCA Connector
Phoenix-type
plug
Output VCA Connecto
r
Output VCA Connector
Shield
2 Setup