Filter
Top Products
Integrated AM/FM/TV Tuner Crestron ST-TUNE
8 •• Integrated AM/FM/TV Tuner: ST-TUNE Operations Guide - DOC. 5833A
NOTE: Equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. The equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
n Consult the dealer or an experienced radio/TV technician for help.
As of the date of manufacture, this unit has been tested and found to comply with
specifications for CE marking.
Setup
Network Wiring
CAUTION: Crestron modular cables are rated for a maximum of two (2) amperes.
Do not exceed this current capacity for any modular device. If more current is
required, connect an appropriate external power pack to the device.
NOTE: If making category 5 connections to the Cresnet peripherals, refer to the
latest revision of the Cresnet Mini Network CAT 5 Interconnect Drawing (Doc.
5819). This document can be obtained from the Products page (PRODUCT
MANUALS, Software and Wiring Diagrams section) or Downloads page (CABLES
and MANUAL Libraries, search for CAT5.PDF) of Crestron’s website
(www.crestron.com). New users are required to register to obtain access to the FTP
site.
NOTE: Review the latest revision of the Network Modular Cable Requirements
(Doc. 5682). This document can be obtained from the Products page (PRODUCT
MANUALS, Software and Wiring Diagrams section) or Downloads page (CABLES
and MANUAL Libraries, search for MODULAR.PDF) of Crestron’s website
(www.crestron.com).
NOTE: The CNHBLOCK should be used when wiring multiple Cresnet devices to
a system. Use only Crestron modular cables when making connections to the
CNHBLOCK modular ports. DO NOT use standard, modular 6-conductor telephone
cables. Most telephone cables are wired in a crisscross fashion and are not
compatible with Crestron equipment.