Filter
Top Products
WR 3M Page 9 of 21
ENFRITESPTNLSVDKFIGRTRCZPLHUSKSLEELVLT
2 s ➾ Menu 1
4 s ➾ Menu 2
1x ➾ ON/OFF
2. The current air flow in percentage is shown in the display for
approximately 2 seconds.
3. Set the desired flow by Depressing the UP or DOWN Scroll Key.
6.4 Switching the Vacuum Pick-up Pump ON/OFF
Z Depress the Pick-Up Radio Button.
The pump is switched on or off, depending on the initial state. In
switched-on mode, the LED (8) next to the Pick-Up Radio Button
lights up green.
Note
The vacuum pump is not designed for continuous operation. (60
Seconds On, 30 Seconds Off). To protect itself, the pump
switches off automatically after 5 minutes of continuous operation.
6.5 Soldering and Desoldering
Z Perform the Soldering / Desoldering work in accordance with the
operating instructions of your connected soldering tool.
7 Special Functions
The special functions are divided into 2 menu levels:
− Menu 1 with setting options for Standby temperature, temperature
deactivation (Setback), automatic switch-off time (AUTO-OFF),
temperature Offset, Window function, Degrees °F / °C conversion,
switch-on time (On Time) for hot-air pencil, vacuum OFF delay
(VAC OFF), vacuum ON delay (VAC ON) and Lock function.
− Menu 2 with setting options for Station Desoldering vacuum level,
ID code, Factory Control Check (FCC), and Pick-Up vacuum level
(%).
Selecting Menu 1 Special Functions
Special functions Navigation
STANDBY
SETBACK
AUTO OFF
OFFSET
WINDOW
°F / °C
ON TIME
VAC OFF
VAC ON
↑ ┌ 1 ┐
↓ ┌ 2 ┐
EXIT ┌ 3 ┐