Filter
Top Products
DSH920S 3
English
2.PRECAUTIONS
1. The first time or when starting after turning
off the backup power supply, the receiver
does not operate normally until reception.
The sound is not heard until 20 or 30 sec-
onds after reception.
2. Text data regarding the names of received
channels is written to the receiver 30 to 60
seconds after start of normal operation. If the
power is turned off before the text data is
written, it may not be correctly displayed next
time. Perform a reset operation if no text data
is displayed.
3. If the receiver freezes, reset it.
● Resetting
Disconnect the SIRIUS Receiver power
cable (the CeNET cable if connected to the
CeNET and the 4-pin power cable during
standalone operation), wait about 10 sec-
onds and connect it again.
The last channel, preset memory and other
data stored in the receiver are deleted re-
turning it to its default settings.
4. A CeNET and standalone operation switch is
provided on the rear of the receiver. The
switch is set to CeNET position at the time of
shipment.
Do not set this switch to the standalone posi-
tion when using the CeNET.
5. The tuner inside the receiver becomes warm
during operation; this is only normal and not
a cause for concern.
6. Do not touch the connector pins on the re-
ceiver as this may damage the ICs inside the
unit.
7. No station is selected when the [a] or [d]
button is moved quickly. This is because but-
ton operations are not accepted until the
channel is confirmed. It takes between 1.5 to
5 seconds to change channels.
CAUTION
This equipment has been tested and found to
comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
dential installation.
This equipment generates, uses, and can radi-
ate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee
that interference will not occur in a particular in-
stallation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to consult the dealer
or an experienced radio/TV technician for help.
USE OF CONTROLS, ADJUSTMENTS, OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN, MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
THE COMPACT DISC PLAYER and MINI DISC
PLAYER SHOULD NOT BE ADJUSTED OR RE-
PAIRED BY ANYONE EXCEPT PROPERLY
QUALIFIED SERVICE PERSONNEL.
CHANGES OR MODIFICATIONS NOT EX-
PRESSLY APPROVED BY THE MANUFAC-
TURER FOR COMPLIANCE COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIP-
MENT.
INFORMATION FOR USERS:.
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE MANU-
FACTURER WILL VOID THE WARRANTY AND
WILL VIOLATE FCC APPROVAL.
Bottom View of Unit
286-
Clarion Co.,Ltd.
MADE IN
2320~2332.5MHz
SIRIUS SATELLITE RADIO
12V GROUND
MODEL
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS :
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
12V GROUND
MADE IN JAPAN
EE-1195B
Clarion Co.,Ltd.
286-9953-00