Filter
Top Products
DSH920S 11
English
1. Attach the mounting brackets 1 to the sides
of the DSH920S using the screws 2 pro-
vided.
2. Select the location on the floor mat. Drill
holes in the floor mat to match the positions
of the holes in the mounting brackets 1.
3. Insert the canoe clips 3 from the rear of the
floor mat and install the DSH920S.
∗ There are three mounting holes on each side
of the DSH920S. Select the appropriate holes
to match to the installation location.
Installation Example
(Installing the unit under the driver’s seat)
Connection Example and Identification of Parts
1 CeNET input/output terminal
Connect to the main unit or CD/MD changer
using the CeNET cable 4.
∗ Equipment to this terminal is not specified.
2 RCA pin terminal
This terminal is not used for this unit. Use it
when the DSC920S (sold separately) is con-
nected.
3 SATELLITE antenna terminal
Connect to the SIRIUS antenna (SATEL-
LITE) cable, (sold separately).
4 TERRESTRIAL antenna terminal
Connect to the SIRIUS antenna (TERRES-
TRIAL) cable, (sold separately).
5 CONTROLLER terminal
This terminal is not used for this unit. Use it
when the DSC920S (sold separately) is con-
nected.
6 POWER SUPPLY terminal
This terminal is not used for this unit. Use it
when the DSC920S (sold separately) is con-
nected.
7 CeNET/STANDALONE switch
This switch is used to select the setting posi-
tion when the CeNET connection is made or
the DSC920S (sold separately) is connected
to this unit (STAND ALONE).
Bottom view of the unit
2
56
3
7
4
1
CeNET cable
SIRIUS
antenna cable