Filter
Top Products
16 ARX8570z
Other Handy Functions
Setting the clock
1. Press and hold ADJ button 4 for 1 second or
longer to switch to the adjustment selection
display.
2. Press the right or left side of SEARCH button
$ to select “CLOCK”.
3. Press ENT button 2.
4. Press the right or left side of SEARCH button
$ to select the hour or the minute.
5. Turn the Rotary knob % clockwise or coun-
terclockwise to set the correct time.
∗ The clock is displayed in 12-hour format.
6. Press ENT button 2 to store the time into
memory.
7. Press ADJ button 4 to return to the previous
mode.
Note:
•
You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the car’s
battery or take out this unit, the clock is reset. While
setting the clock, if another button or operation is
selected, the clock set mode is canceled.
Dimmer level setting
You can reduce the display illumination linked to
the car illumination.
∗ The factory default setting is “LEVEL 3”.
1. Press and hold ADJ button 4 for 1 second or
longer to switch to the adjustment selection
display.
2. Press the right or left side of SEARCH button
$ to select “DIMMER LV”.
3. Press ENT button 2.
4. Turn the Rotary knob % clockwise or coun-
terclockwise to set the dimmer level. Choose
the dimmer level from the following.
“OFF”, “LEVEL 1”, “LEVEL 2”, “LEVEL 3”,
“LEVEL 4”, “LEVEL 5”.
LEVEL 1 to LEVEL 5:
The greater the dimmer level is, the more the
illumination is reduced.
OFF:
Even if the car illumination is turned on, re-
duction of the display illumination does not
occur.
5. Pressing ENT button 2 returns to the adjust-
ment selection display.
6. Press ADJ button 4 to return to the previous
mode.
Tape selection repeat
The tape selection repeat continuously plays the
current track. This function continues automatically
until it is canceled.
1. Press RPT button 6. “RPT” lights in the dis-
play and the current track is repeated.
2. To cancel the repeat play, press RPT button
6 again. “RPT” goes off from the display and
normal play resumes.
Blank tape skip
The blank tape skip allows you to skip blank sec-
tions of tape that are over 12 seconds long.
1. Press and hold RPT button 6 for 1 second
or longer. “BLS” lights in the display and the
mechanism fastforward to the next track se-
lection.
2. To cancel the blank tape skip, press and hold
RPT button 6 for 1 second or longer again.
“BLS” goes off from the display and normal
play resumes.
Notes:
The APC, intro tape scan, tape selection repeat and
blank skip may not work properly with tapes of the
following qualities:
• Tapes on which the recording level is too low.
• Tapes on which there is much noise between se-
lections.
• Tapes on which there are long pauses in the middle
of selections.
• Tapes on which there are less than 4 seconds of
blank space between selections.
Tape Operations