Clarion ADB340MP Stereo System User Manual


 
ADB340MP/ADB341MP 38 ADB340MP/ADB341MP ADB340MP/ADB341MP 4
2. PRECAUTIONS
1. When the inside of the car is very cold and
the player is used soon after switching on the
heater, moisture may form on the disc or the
optical parts of the player and proper play-
back may not be possible. If moisture forms
on the disc, wipe it off with a soft cloth. If mois-
ture forms on the optical parts of the player,do
not use the player for about one hour. The
condensation will disappear naturally allow-
ing normal operation.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the sound
to skip.
3. This unit uses a precision mechanism. Even
in the event that trouble arises, never open
the case, disassemble the unit, or lubricate
the rotating parts.
This equipment has been tested and found to
comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
dential installation.
This equipment generates, uses, and can radi-
ate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee that
interference will not occur in a particular instal-
lation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to consult the dealer
or an experienced radio/TV technician for help.
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN, MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
THE COMPACT DISC PLAYER SHOULD NOT BE
ADJUSTED OR REPAIRED BY ANYONEEXCEPT
PROPERLY QUALIFIED SERVICE PERSONNEL.
CHANGES OR MODIFICATIONS NOT EX-
PRESSLY APPROVED BY THE MANUFACTURER
FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE MANU-
FACTURER WILL VOID THE WARRANTY AND
WILL VIOLATE FCC APPROVAL.
Top View of Source Unit
MODEL
12V
GROUND
AM 530-1710kHz/FM 87.9- 107.9MHz
SERIAL No.
PE-2652B
28A51690
Clarion Co., Ltd.
MADE IN INDONESIA
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR
SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE.
CLARION CO., LTD.
50 KAMITODA, TODA-SHI, SAITAMA-KEN, JAPAN
MANUFACTURED:
Be sure to unfold and read the next page.
Veuillez déplier et vous référer à la page suivante.
Cerciórese de desplegar y de leer la página siguiente.
Flip Down Panel
This unit uses a flip-down structure that makes
possible large-size display.
CAUTION
When opening and closing the FLIP DOWN
PANEL, be careful not to catch your fingers.
They could be injured.
1. Always use this unit with the FLIP DOWN
PANEL closed.
2. Do not force operations or use this device
abnormally when opening or closing the FLIP
DOWN PANEL.
3. Do not use the FLIP DOWN PANEL as a tray
to place objects on when it is open.
4. When closing the FLIP DOWN PANEL, do not
press the [OPEN] button.
5. Strong impacts to the operating or display
section can cause damage or deformation.
6. If the FLIP DOWN PANEL does not open fully,
gently open it with your hand.
3 (8 cm) Compact Discs
CAUTION
3 (8 cm) disc cant be played. Using an
adapter and inserting them into this unit can
cause damage, please do not insert by any
means.
Handling Cassette Tapes
Handling Compact Discs
Handling
Compared to ordinary music CDs, CD-R and CD-
RW discs are both easily affected by high tem-
perature and humidity and some of CD-R and
CD-RW discs may not be played. Therefore, do
not leave them for a long time in the car.
New discs may have some roughness around
the edges. If such discs
are used, the player may
not work or the sound may
skip. Use a ball-point pen
or the like to remove any
roughness from the edge
of the disc.
Never stick labels on the surface of the compact
disc or mark the surface with a pencil or pen.
Never play a compact disc with any cellophane
tape or other glue on it or with peeling off marks.
If you try to play such a compact disc, you may
not be able to get it back out of the CD player or
it may damage the CD player.
Do not use compact discs that have large
scratches, are misshapen, cracked, etc. Use of
such discs may cause misoperation or damage.
Use only compact discs bearing the or mark.
Do not play heart-shaped, octagonal, or other specially shaped compact discs.
Some CDs recorded in CD-R/CD-RW mode may not be usable.
Using any of the following types of cassette tapes
can cause malfunctions.
Cassette tapes with low recording levels
• Cassette tapes in which the unrecorded sec-
tion between songs is shorter than 4 seconds
Cassette tapes with noise or the like recorded
between songs
Cassette tapes on which there are long unre-
corded sections in the middle of a song
Handling precautions
• Slack in the tape can cause malfunctions. In
particular for prerecorded
cassette tapes and 90-
minute tapes, take up any
slack in the tape before
inserting it into the cas-
sette player.
Avoid using cassettes of 120 minutes or longer.
(Such cassettes have extremely thin tape, so
the tape can become stretched or cut.)
Periodically play a cleaning cassette in the
player to clean the head.
• Keep magnets, screwdrivers, and other iron
and steel and magnetic items away from both
cassette tapes and the tape head in the player.
Do not oil the cassette mechanism.
Do not use any cassette tapes with peeling la-
bels or deformed cases. Such cassette tapes
can cause breakdowns.
When not using the player, always take the cas-
sette out of the mechanism. Exposing a cas-
sette to direct sunlight, extreme temperatures,
or high humidity can damage the cassette.
Ball-point pen
Roughness
To remove a compact disc from its storage case,
press down on the center of the case and lift the
disc out, holding it carefully by the edges.
Do not use commercially available CD protec-
tion sheets or discs equipped with stabilizers, etc.
These may damage the disc or cause breakdown
of the internal mechanism.
Storage
Do not expose compact discs to direct sunlight
or any heat source.
Do not expose compact discs to excess hu-
midity or dust.
Do not expose compact discs to direct heat
from heaters.
Cleaning
To remove fingermarks and dust, use a soft
cloth and wipe in a straight line from the center
of the compact disc to the circumference.
Do not use any solvents, such as commercially
available cleaners, anti-static spray or thinner
to clean compact discs.
After using special compact disc cleaner, let
the compact disc dry off well before playing it.
5. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.
Turning on/off the power
Notes:
Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press the [FNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FNC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [FNC] button to change the mode
of operation.
2. Each time you press the [FNC] button, the
mode of operation changes in the following
order:
Radio mode CD mode Tape mode
AUX mode Radio mode...
Adjusting the volume
Turning the [VOLUME] knob clockwise to in-
crease the volume, or turning the [VOLUME]
knob counterclockwise to decrease the volume.
The volume level is from 0 (minimum) to 35 (maxi-
mum).
Mute
Turning the volume down quickly.
Press the [MUTE] button.
Each time the button is pressed the Mute turns
ON or OFF.
When its ON, the MUTE indicator blinks.
Switching the display
Press the [DISP] button to select the desired dis-
play.
Each time you press the [DISP] button, the dis-
play switches in the following order:
In Tuner source
Frequency Clock Frequency...
In CD source
Clock Track Number & Track Time Clock...
In Tape source
Playback direction & Current status Current
status Clock Playback direction & Current
status...
Once selected, the preferred display becomes
the display default. When a function adjustment
such as volume is made, the screen will mo-
mentarily switch to that functions display, then
revert back to the preferred display several
seconds after the adjustment.
When you have entered a title in a CD, it ap-
pears in the main display. If you have not en-
tered a title, NO-TITL appears in the title dis-
play instead. For information on how to enter a
title, refer to the subsection Entering titlesin
the Operations Common to Each Mode.
03.12.17, 0:07 PMPage 3