Filter
Top Products
8
Autotune local - scans all frequencies in the UK channel allocation. This should only take a few seconds.
Autotune full - scans the full range of digital frequencies in Band III. This may take a minute or more.
1. Ensure your EVOKE-1 Elgar is switched on and the aerial is connected and fully extended.
2. Push and release the Autotune button once for local scan or hold down for around two seconds for a full scan.
Note You can cancel Autotune by pushing the Autotune button again during the tuning process.
The display will indicate tuning is underway. When finished, the EVOKE-1 Elgar will return to the station you were
listening to and you will hear it through the speakers. All the stations found are now stored in the unit and you
can select another station as described in Selecting a station on page 9.
If no stations are found, you see the message ‘No stations available’ and the display shows an option menu,
see If no stations are found during the autotune on page 7 for details of this menu. Check your aerial is fully
extended and try one of the available tuning options.
Retuning your unit
You can re-tune your unit at any time using the autotune process. You may wish to do this if a new multiplex is launched
or you move your unit to another room. You do not need to perform an autotune to pick up new stations within a
multiplex you are listening to as your EVOKE-1 Elgar monitors and refreshes the list of available stations automatically.
The following two options are available:
Adjusting the volume
Once you have tuned your EVOKE-1 Elgar as explained above you can adjust the volume using the Vol knob.