Filter
Top Products
7
Switching on and off
Before switching on for the first time, check all connections, extend your aerial and ensure that the volume is low.
Push and release the Power button to switch the unit on or off. The LCD screen will light up when the unit is on.
Tuning
Using your EVOKE-1 Elgar
This section provides information on using your EVOKE-1 Elgar including tuning, selecting a station and altering the displayed information.
Tuning the EVOKE-1 Elgar is very simple. When you first switch on the unit it will start an automatic tuning process
described below in Tuning for the first time. You may want to re-tune the unit at a later date if you move the unit to a
different room or if you want to receive a newly introduced multiplex – see Retuning your unit on page 8.
Tuning for the first time
When you switch on your EVOKE-1 Elgar for the first time an autotune process will be performed automatically. A
progress indicator on the display shows that autotune is underway.
If stations are found during the autotune
The stations will be stored in alphanumeric order. The first station on the list will be selected and you will hear it
through the speaker. To listen to other stations, see Selecting a station on page 9.
If no stations are found during the autotune
‘No stations available’ will be shown on the display for a few seconds and then you see a menu of options.
Use the Tune knob to scroll through the following options and push it to select that option.
Tuning aid - See Tuning aid on page 12 for details of using the tuning aid to improve reception.
Autotune local - See Retuning your unit below for details of the local autotune option.
Autotune full - See Retuning your unit below for details of the full autotune option.