Filter
Top Products
12
Learning I.R. Codes:
You may teach the AVS550 remote control the codes
from up to three other remote controls. Once you have
programmed the new codes, the AVS550 remote will
operate your entire system.
1. Press and hold the REMOTE SOURCE button (TV,
VCR, or CABLE) you wish to program for 3 seconds
until the status LED above the ANGLE button illumi-
nates a steady GREEN.
2. Face the remote whose command you wish to learn
(source remote) towards the small window above
the ZOOM button of the ASV550 remote. Keep
them approximately 3-4 inches apart.
3. Press the button on the source remote that you
wish to teach the AVS550 remote. The LED will turn
AMBER.
4. Press the button on the AVS550 remote where you
want to assign the new code. When the command
was successfully learned the LED on the AVS550
remote illuminates a steady GREEN. If the Green
LED flashes, there was an error and you must try
again.
5. The remote is now ready to learn the next com-
mand. Press the next button on the source remote
you wish to learn and repeat the process.
6. Repeat as needed until all the commands you need
to operate he system are learned. After 10 seconds
of inactivity the remote will leave learning mode, the
green LED will extinguish, and the remote control is
ready for use.
Hint: Only save the commands you need to use from
the source remote. There is usually no reason to save
all the commands. It may be easiest to combine
selected commands from various sources under one
REMOTE SOURCE button. For example, if you always
use a cable box or satellite tuner it will be easier to
save the TV input source switching and cable box
channel selection buttons under TV. You will not need
to save the channel commands from the TV.