Filter
Top Products
SR10
9
ENGLISH
Mains Voltage Selector Switch
115V/230V AC~50/60Hz
Power AC
CD BD / DVD MP3 / Aux MM Phono Rec Out
Ground
CD
BD / DVD
MP3 / Aux
MM PhonoRec Out
Right
Left
Right
Left
Loudspeaker Terminals
Impedance 4–8 ohms
LeftRight
A
B
A
B
Left Right
Manufactured in an
ISO9001 approved facility
AM 300ΩFM 75Ω Service Port
Loudspeaker Terminals
Impedance 4–8 ohms
LeftRight
A
B
A
B
Left Right
Speaker B connections
The Speaker B connections on the back of the amplifier allow for a second
set of speakers to be used (i.e. speakers located in another room).
The Speaker A/B button on the front panel and remote control allows the
two sets of speakers to be toggled on and off. Refer to the Front Panel or
Remote Control section of this manual for more information on the
Speaker A/B operation.
Bi-wire connections
If your loudspeakers are equipped with two sets of terminals, then it is
possible to connect them in the bi-wire configuration. Bi-wiring sends the
bass and treble frequencies down separate speaker cables, resulting in
a clearer, more focussed sound.
Note:
– Speaker A and B must both be selected for this type of connection to
work.
– Remove the bi-wire link on the speaker terminals before connecting.
Refer to your speakers’ manual for more information.
SR10
Speaker A
Main Room
Speaker B
Room Two
HF
LF
Either A or B, or both A and B may be selected for use.
Note: When using two pairs of speakers, use speakers with a nominal
impedance of 8 ohms each.
HF
LF
HF
LF
HF
LF
Right
speaker
Left
speaker
Red
Red BlackBlack Red
Black
RedBlack
Red
Black
RedBlack