Filter
Top Products
Mains Voltage Selector Switch
115V/230V AC~50/60Hz
Power AC
Caution
Serial Number Label Removed
CD
BD / DVD MP3 / Aux
MM Phono Rec Out
Ground
CD
BD / DVD
MP3 / Aux
MM PhonoRec Out
Right
Left
Right
Left
Loudspeaker Terminals
Impedance 4–8 ohms
LeftRight
A
B
A
B
Left Right
Made under licence in China
Manufactured in an
ISO9001 approved facility
This device complies with part 15 of the FCC
Rules. Operation is subject to the condition that
this device does not cause harmful interference.
AM 300ΩFM 75Ω Service Port
Do not obstruct ventilation / Ventilation nicht verschließen /
Ne pas obstruer la ventilation
Important
Please ensure that loudspeaker terminals are fully tightened.
Veuillez s'assurer que les bornes de l'enceinte sont
entièrement serrées
Europe FM: 87.50MHz - 108.00MHz
US FM: 87.50MHz - 108.00MHz
Europe AM: 522kHz - 1629kHz
US AM: 530kHz - 1710kHz
CONFORMS TO ANSI/UL
STD 60065
7TH EDITION 2003
CERTIFIED TO CAN/CSA
STD C22.2
No. 60065-03
3132407
Rated Power Consumption: 500W
Designed and engineered in London, England
Topaz SR10 Stereo Receiver
www.cambridge-audio.com
SR10
5
ENGLISH
Rear panel connections
Audio inputs
These inputs are suitable for any ‘line level’ source equipment such as the
audio outputs of CD players, BD/DVD players, etc.
Phono input
This input has a built in phono stage. Record players fitted with Phono
Cartridges of the Moving Magnet (MM) or high output
Moving Coil (MC)
type (between 2-6mV output and 30-50k load impedance) can be used.
Low output Moving Coil types (<1mV and usually 10-1000 ohm load
impedance) cannot be directly connected and will require a matching
transformer or head amp. Please consult your dealer for details. The
‘ground’ terminals on both the record player and the SR10 should be
connected (where possible) with a ground wire for lowest noise/hum
pickup.
Rec Out
Connect to the recording input of a tape deck, CD recorder input, etc.
AM/FM antenna
Tuner aerial connections for picking up radio signals. Refer to the
‘Connections’ section of this manual. For permanent use, outdoor AM/FM
aerials are highly recommended.
Service port
For servicing use only. Do not connect anything here as it may result in
damage.
Loudspeaker terminals
Two sets of loudspeaker terminals are available, A (main loudspeaker
terminals, top row) and B (secondary switchable loudspeaker terminals,
bottom row). Connect the wires from your left channel loudspeaker to the
Left positive and negative terminals, and the wires from the right channel
loudspeaker to the Right positive and negative terminals.
In each case, the red terminal is the positive output and the black
terminal is the negative output.
Care should be taken to ensure no stray strands of wire are shorting
speaker outputs together. Please ensure that the loudspeaker terminals
have been tightened adequately to provide a good electrical connection.
It is possible for the sound quality to be affected if the screw terminals are
loose.
The use of A and B speakers affords you an easy and inexpensive way to
create a simple multi-room system.
Note: When using two pairs of speakers, use speakers with a nominal
impedance of 8 ohms.
Voltage select switch
For servicing use only.
AC power socket
Once all connections are complete, plug the AC power cable into an
appropriate mains socket and turn the unit on.
1
1
5
2 3
6
4
8
7
2
3
4
5
6
7
8
Aerials
Note: The SR10 is supplied with a temporary aerial for initial use. For
permanent use, outdoor aerials are highly recommended.
AM loop aerial
Connect each end of the single length antenna to the antenna terminals.
Place the antenna as far from the main system as possible to prevent
unwanted noise and to obtain optimum reception. If the AM loop aerial
provided does not provide sufficient reception, it may be necessary to use
an outdoor AM aerial.
FM aerial
Connect the supplied aerial to the FM 75 ohm socket. Extend and move
the aerial lead around until you get the best reception. For continued use,
we strongly recommend using a 75 ohm outdoor FM aerial.
CD
BD
/
D
V
D
MP
3
/
A
ux
MM Phono Rec Ou
t
Gr
ou
n
d
CD
BD
/
DVD
MP3
/
A
u
x
MM
Pho
n
o
Rec
Out
Right
L
e
f
t
Right
Lef
t
L
ou
d
spea
k
er
T
erm
i
na
ls
Impedance 4–8 ohms
Le
ft
Ri
g
ht
A
B
A
B
A
M 300
Ω
F
M 75
Ω
Service Por
t
Rated Power
C
onsumption
:
500W
D
es
i
gne
d
an
d
eng
i
neere
d
i
n
L
on
d
on,
E
ng
l
an
d
Topaz SR10 Stereo Receiver
w
ww.cam
b
r
idg
e-au
di
o.co
m
AM 300ΩFM 75Ω