Filter
Top Products
17
Pressing the OSD (On-Screen Display) Button will toggle the OSD function on and off, on your video monitor,
if you are using the Bryston SPV-1 video switcher.
Pressing the SUB button will engage the menu for the volume trim level of the subwoofer channel. Use the
MENU/UP/DOWN button to change the subwoofer channel level up or down. Press SELECT when finished.
Pressing the CENTER button will engage the menu for the volume trim level of the center channel. Use the
MENU/UP/DOWN button to change the center channel level up or down. Press SELECT when finished.
Pressing the REAR button will engage the menu for the volume trim level of the rear channels. Use the
MENU/UP/DOWN button to change the rear channel levels up or down. Press SELECT when finished.
Pressing the BACK button will engage the menu for the volume trim level of the back channel(s). Use the
MENU/UP/DOWN button to change the back channel level(s) up or down. Press SELECT when finished.
12. Status LED
Indicates remote control status while accessing discrete/hidden functions, and changing remote options. Contact
the factory for details.
13. Photo Sensor
Works in conjunction with the backlight and tilt switch to determine if backlighting is needed.
NOTE: To enable or disable the backlight in the remote control, follow this procedure:
i. Press CODE button for 5 seconds
ii. LED will flash red, then release button
iii. Type in 3 digit code 792 = MODE / SAVE / DTS
iv. LED will flash again to confirm
To send discrete/hidden Code…
i. Press CODE button and release
ii. LED will illuminate (Red)
iii. Type in 3 digit code (a combination of mode buttons)
iv. LED will flash again to confirm and go out.
For a list of hidden codes, visit the Bryston Website at www.bryston.ca