Filter
Top Products
11
Alarms (continued)
Checking the wakeup time
Stopping the alarm when it is sounding
Disabling the alarm (for weekends, etc.)
Using the Snooze function
Press the Setup button for Alarm 1 (or Alarm 2). The wakeup
time and other alarm settings will flash in the display for a few
seconds. To cancel the flashing immediately, press the Setup
button again.
Press the On/off button or any other button except the
Snooze/Sleep button. The alarm will stop, and will trigger again at
the same time the next day.
When the alarm sounds, press the Snooze/Sleep button
on the MicroSystem CD or the Sleep button on the Remote
Control once to silence the alarm for 10 minutes.
If the Snooze/Sleep button or the Sleep button is pressed
again within 3 seconds of the first push, 5 minutes will be
added to snooze time, up to a maximum of 60 minutes.
Example: If the button is pushed rapidly three times, the
MicroSystem CD will go into snooze mode for 20 minutes
(10 + 5 + 5 minutes).
Once the MicroSystem CD is in snooze mode, tapping
the Snooze/Sleep or Sleep button will display the remain-
ing snooze time, counting down. The display will then revert
to normal after 5 seconds.
Press the Alarm 1 (or Alarm 2) button repeatedly until the alarm
icon disappears in the display. The alarm settings will remain stored,
but the alarm will not be active.
kr
T
/
e
n
uT
D
C
M
AM
F
f
f
o/
n
O
o
f
n
I
e
t
u
M
1
pee
l
S
k
rT
/
e
n
uT
D
C
M
A
M
F
f
f
o
/n
O
o
f
n
I
e
t
u
M
1
p
ee
l
S
kr
T
/
e
nu
T
D
C
M
A
M
F
f
f
o/n
O
o
f
n
I
e
t
u
M
1
pe
e
l
S
k
rT
/
e
nuT
D
C
M
A
M
F
f
f
o/
n
O
o
f
n
I
e
t
u
M
1
p
e
e
l
S