Filter
Top Products
7
Setup
English FrançaisEspañol
Connecting the Multi-CD Changer to your Wave
®
music system
IMPORTANT!
Please make sure you
update your Wave
®
music
system before setting up
the Multi-CD Changer.
See “Updating your
Wave
®
music system” on
page 4.
Before you start this setup procedure, disconnect the AC power cord on your
Wave
®
music system and set it aside. You will need to use it again in Step 3.
1. Plug the Bose
®
link cable from the changer into the Bose
®
link connector on your Wave
®
music system.
2. Plug the changer power cord into the AC power input connector on the back of the
Wave
®
music system.
3. Plug the Wave
®
music system AC power cord into the AC power input connector on the
back of the changer.
4. Plug the other end of the AC power cord into an AC (mains) wall outlet.
After applying power, “PLEASE WAIT” appears on the display for about 30
seconds while the system prepares itself for operation. DO NOT insert any
discs until this message disappears.
5. For best FM reception, straighten the AC power cord as much as possible. Your Wave
®
music system uses the power cord as an FM antenna.
Bose
®
link
connector
Wave
®
music
system
AC POWER
input
Wave
®
music system
AC power cord
Bose
®
link cable
Wave
®
music
system
Multi-CD
Changer
Changer
power
cord
For best FM reception,
straighten the power
cord as much as !
possible.
1
2
3
4
5