Filter
Top Products
8
S
ETUP
EnglishFrançais Español
Making the power connections
1. Insert the DC power cord from the power pack into the DC Power jack on the rear panel
of the RoomMate
®
speaker. Make sure the DC Power label faces up (Figure 5).
2. Insert the small connector of the AC power cord into the power pack. Plug the other end
into an appropriate AC receptacle.
The speaker is now in standby mode, ready to use. Turn to
“Installing batteries in the PERSONAL
music center II” on page 9.
Figure 5
RoomMate speaker power
connections
Power pack
AC power cord
DC power cord
Make sure DC Power
label faces up.
Small connector of
AC power cord
DC power jack