8
Français Español English
Operation
Remote control guide
An additional remote control is included with your Wave
®
music system Multi-CD Changer. This
remote is identical to the one used to control your Wave
®
music system. So, you can use either
remote to control the completed multi-CD system. Just aim the remote at the front panel and
press the buttons. The remote normally works within 20 feet of the front panel.
The following diagram describes the buttons used for playing CDs using the disc changer.
Seek/Track
• Press: Skips to next/previous CD track
on the current disc.
• Press and hold: Rapidly skips to next/
previous CD track on the current disc.
Tune/MP3
• Press: Navigates between folders
when playing MP3 CDs.
• Press and hold: Rapidly scans forward/
backward through a CD track.
Play/Pause
• Press: Plays the current CD.
• Press again: Pauses a playing CD.
Stop/Eject
• Press once: Stops playing the current CD
(page 10).
• Press again: Ejects the stopped CD.
• Press and hold: Ejects a playing CD.
Play Mode
• Selects CD play modes (page 11).
AUX
• Press to hear audio from an external
source connected to either the AUX 1 or
AUX 2 input on the changer (page 12).
• Press to switch between the AUX 1 and
AUX 2 input (page 12).
CD
• Press: Selects the CD source (page 10).
• Press again: Moves to the next disc
(page 10).
Note: Press-and-hold operations require holding the button down for at least one second.
Note:
Pressing FM/AM, CD, or AUX automatically turns on the Wave
®
music system to the
source selected.
Throughout this owner’s guide you will see button icons to the left of the operating instruc-
tions. These icons refer to buttons located on the remote control.
Turning your multi-CD system on and off
Press On/Off once to turn your multi-CD Wave
®
music system on or off. The system turns on
to the last source played. If the last source was CD, the last disc selected starts to play.
Press On/Off again to turn the system off.
OR
Press CD to turn the system on to the CD source. The last disc selected will play.