Filter
Top Products
14 December 20, 2001 AM262838_00_V.pdf
Connecting the Acoustimass
®
module to the Model 20 music center
Note:
To extend the length of the cables, use the supplied 50-foot extension cable (shown
in the dotted line above). This cable connects between the 30-foot audio input cable and the
3-foot VAR adapter cable (Figure 15).
To connect the Acoustimass 5 or 20 powered speakers to your system (Figure 15), follow
these steps:
1. Using the supplied 30-foot audio input cable, insert the round DIN connector into the
Acoustimass module, and the RCA plugs into the supplied 3-foot adapter cable labeled
VAR on the single-connector end.
2. Attach the end of the 3-foot VAR adapter cable to the ZONE 2 output jack on the rear of
the Model 20 music center.
Setting up the remote control
You need to set up a second remote control to operate the ZONE 2 outputs.
1. Remove the remote control battery cover and locate the miniature switches (Figure 16).
2. Make sure that the house code settings (switches 1, 2, 3, and 4) match those on your first
remote.
3. Set switch 8 up for ZONE 2.
Figure 16
Setting up the remote control
Connecting power to your system
CAUTION
: If you purchased a dual-voltage system, it is important that you set the speakers
to the correct voltage. To do this, refer to “Selecting the correct voltage” on page 6.
Follow these steps to connect power to your Acoustimass powered speaker system:
1. Plug the power cord from the Acoustimass module into an AC power (mains) outlet.
2. Insert the power cords of the Lifestyle
®
system into an AC power (mains) outlet.
3. Turn the Acoustimass module power switch to the On position.
VAR
Figure 15
Connecting the speakers to
your Model 20 music center
Setting Up