Filter
Top Products
AM262838_00_V.pdf December 20, 2001 9
Connecting the Acoustimass
®
module to multi-room interface systems
Note:
To extend the length of the cables, use the supplied 50-foot extension cable (shown
in the dotted line above). This cable connects between the 30-foot audio input cable and the
3-foot VAR adapter cable.
To connect the Acoustimass 5 or 20 powered speakers to your system, follow these steps:
1. Using the supplied 30-foot audio input cable, insert the round DIN connector into the
Acoustimass module, and the RCA plugs into the supplied 3-foot VAR adapter cable
labeled VAR on the single-connector end.
2. Attach the single-connector end of the 3-foot VAR adapter cable to one of the unused
ROOM output jacks (B, C, D) on the rear of the multi-room interface (Figure 11).
Connecting power to your system
CAUTION
: If you purchased a dual-voltage system, it is important that you set the speakers
to the correct voltage. To do this, refer to “Selecting the correct voltage” on page 6.
Follow these steps to connect power to your Acoustimass powered speaker system:
1. Plug the power cord from the Acoustimass module into an AC power (mains) outlet.
2. Insert the power cord of the Lifestyle
®
system into an AC power (mains) outlet.
3. Turn the Acoustimass module power switch to the On position.
Operating in more than one room
Your Lifestyle
®
system Personal
®
music center can control up to four sets of Bose
®
powered
speakers, allowing your family to enjoy four different audio sources (CD, radio, TV, etc.) in up
to four rooms. These rooms are referred to as room A, B, C, and D, with room A being the
primary room (the one used for a one-room system). If two or more rooms are connected to
your system, the Personal music center displays ROOM and HOUSE buttons, and room
indicators (A, B, C, and/or D). Figure 12 shows a sample display for a two-room system.
OFF
POWER
ON
RIGHT
OUTPUTS
TO
CUBE
SPEAKERS
LEFT
AUDIO
INPUT
ANTENNA
FM AM
LOCATE
MUSIC
CENTER
BOSE CD
AUX VIDEO 1 VIDEO 2 TAPE IN OUT
LLLLL
RRRRR
RECORD
ROOM A
(PRIMARY)
ROOM B
ROOM DROOM C
POWER
SERIAL
DATA
!
SEE USER’S
GUIDE
12V AC
1.6A
AUDIO INPUT AUDIO OUTPUT
Note:
Do
not
plug the AC power pack into a power outlet until all component connections
are complete.
Figure 11
Connecting the speakers to
your multi-room interface
Setting Up
VAR