Barco PGWX-62L-K Home Theater System User Manual


 
21
PGWX-62L/PGWU-62L/PGWX-62L-K/PGWU-62L-K - - 2015/07/27
3. Installation
3.4 Powering On/Off the Projector
Ensure that the power cord and signal cable are securely connected. Power on the switch1.
1
and wait until the
Status LED is solid red.
Turn on the projector by pressing “2. ” on the remote control or the control panel. The Status LED is off.
2
The startup screen displays in approximately 10 seconds.
Turn on your source. Select an input source by the remote control (HDMI, VGA, DVI or Video). 3.
The projector detects the source you selected and displays the image.
VGA-OUT VGA-IN
LAN RS-232 12V
OUT
5V
OUT
CVBS
HDMI
DVI
Enter
Menu
1
Power Switch
2
Power button
3.4.1 Powering On the Projector
Procedure:
Status LED
IR Receiver
Press “1. ” key of on the remote control or the control panel, a message displays on the projector’s screen.
Press “2. ” key again to conrm, otherwise the message disappears after 5 seconds.
3.4.2 Powering Off the Projector
Procedure:
CAUTION: Don’t turn on the projector immediately after entering Standby mode.
VGA-OUT VGA-IN
LAN RS-232 12V
OUT
5V
OUT
CVBS
HDMI
DVI
Enter
Menu
or