Filter
Top Products
12
PROCEDURE FOR A TYPICAL BRACKET INSTALLATION OF THE SCU
(Bracket not supplied)
© Copyright 2001 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788
128-6213A
Audiovox suggests this type of installation over the Hook & Loop type of installation though the Hook & Loop
installation (if done correctly) is a secure and sufficient mounting option. Installation of the SCU using a
bracket results in a professional, factory-installed look, without visibly damaging the interior of the vehicle.
When combined with the optional Trim Ring (model #SAT-PF) the results are further cosmetically en-
hanced. There are several types of brackets available to accomplish this type of installation.
The installation procedure that follows, illustrates the use of a Pro.Fit
®
mounting bracket. Audiovox has
found that the Pro.Fit
®
VSM
®
line of mounting brackets are easy to install and compliments the installation
of the SCU as well as being a perfect match to the optional Trim Ring (model #SAT-PF). Pro.Fit
®
VSM
®
mounting bracket reduce the installation liability while maintaining the resale value of a car because of the
professional fit, professional look and safe design.
Currently Pro.Fit
®
VSM
®
offers hundreds of brackets, covering most popular cars, vans, and trucks. Step-
by-step instructions and technical support are available for every mount and application.
After the proper mounting bracket has been selected and installed using the Original Manufacturers
installation instructions, proceed with the following steps:
1. Feed the SCU Cable through the hole in the Trim Ring (optional) and connect it to the
RF Modulator.
2. Using the Phillips Head Screws and the External Tooth Lock Washers (supplied),
Mount the SCU to the bracket as shown in the Figure below.
NOTE: Use caution not to over tighten the screws into the back of the SCU as this may
cause damage to the unit.
Upon completion of the SCU installation and before the XM radio is activated a test of the system should be
performed. To verify that the SRXM-001 system and the antenna have been installed correctly and are
functioning, select and listen to CH 1. (XM preview channel). If there is no power to the SCU check that all
connections have been made and that fuses are good. If there is no signal present, make sure that the
antenna is unobstructed (move vehicle) and check the antenna cable connection to the RF Modulator. For
a detailed trouble-shooting guide, refer to the Owner’s Manual.
Do not install the unit in the following locations:
In Locations exposed to direct sunlight. Where hot air is discharged from the car heater. In areas
subject to extreme temperatures.
NOTE:
0
SFT
3
9
6
2
8
5
1
7
4
A
U
D
IO
O
X
(Example installation position)
Phillips Round Head Screw (4mm x 8mm)
External Tooth Washer
(4mm int.)
Trim Ring
(Not Supplied, Model #SAT-PF)
For ordering information call Audiovox Electronics toll-free telephone assis-
tance line at 1-800-645-4994 or contact us via the web:
www.audiovox.com
Bracket
(Not Supplied)
Bracket Shown is a PRO.FIT for ordering information
visit www.pro-fit-intl.com
SCU