Filter
Top Products
-4-
The PEQ-200 should be easily accessible to the operator,
and is intended for in-dash (if a location is available),
console, or under-dash mounting as shown. To install the
unit, proceed as follows:
1. Carefully choose a favorable mounting location prior
to wiring the unit. Before deciding on the mounting
location, consider these points:
a. Will the unit be accessible for easy operation
while driving?
b. Is it a good solid mounting surface?
c. How will the wiring be routed to reach the unit?
d. Will it obstruct or interfere with passengers or
other controls?
2. After choosing the location, position the mounting
bracket and mark the location of the four screws on
the surface, two at each end.
3. Remove the bracket and drill a 3/32" hole at the four
locations.
CAUTION: Do not use any screws other than those
provided with this unit. Use of longer screws
may short-circuit or damage internal components
of the unit.
4. Place the bracket in position and secure it to the
mounting surface using the four self-tapping
screws,flat washers and lockwashers provided.
5. Attach the PEQ-200 to the mounting bracket using
two machine screws through the bracket into each
side of the unit. Since the mounting bracket holes
are elongated vertically, the unit can be secured in
a tilted fashion to enhance control accessibility.
INSTALLATION PROCEDURES
Under-Dash Installation
Typical In-Dash Installation
EXISTING CAR
RADIO
PEQ-200
CROSSOVER/EQUALIZER
MOUNTING
BRACKET
PEQ-200
CROSSOVER/EQUALIZER