Filter
Top Products
-8-
6 STATION PRE-SET TUNING ( / ) – See Main Unit bl
PRE-SET SCAN TUNING – See Main Unit bn
TAPE FAST-FORWARD ( ) – See Main Unit cm
FAST-FORWARD AUTOMATIC MUSIC SEARCH ( )
– See Main Unit cm
TAPE REWIND ( ) – See Main Unit cn
REWIND AUTOMATIC MUSIC SEARCH – See Main Unit cn
CD CHANGER DISC SELECT – See Main Unit cu
7 DISPLAY RECALL (DISP) – See Main Unit bu
8 CD TRACK/DISC REPEAT (RPT) – When the Repeat button
is pressed once, the RPT indication will appear on the display
panel and play of the selected track will be continually repeated
until the Track Repeat mode is cancelled by pressing the
Repeat button twice or activating the Track Scan function so
that the RPT indication disappears from the display panel.
When the Repeat button is pressed twice, the D-RPT
indication will appear on the display panel and play of the
selected disc will be continually repeated. The Disc Repeat
mode can be cancelled by pressing the Repeat button again
or by activating the Track Scan function so that the D-RPT
indication disappears from the display panel.The Track and
Disc Repeat functions are not available on the Main Unit.
9 CD TRACK SCAN (SCAN) – During disc play, press this
button to play the first 10 seconds of each track on the disc
(SCN will appear on the display panel). When a desired track
is reached, press the Scan button again to cancel the function
(SCN will disappear from the display panel) and play of the
selected track will continue. Track Scan mode will also be
cancelled by activating the Track or Disc Repeat functions.
The Track Scan function is not available on the Main Unit.
bl INFRARED SENDER
bm BATTERY COMPARTMENT
bn THESE BUTTONS NOT FUNCTIONAL WITH THE PAV-1
NOTES ON REMOTE CONTROL USE
1. The remote control operates on a 3-volt lithium battery (type
CR-2025). Install the battery into the compartment at the bottom
of the remote control, making sure to observe correct polarity as
shown in the diagram on the back of the control.
2. If the remote control fails to operate, always check battery
condition and replace if necessary before servicing the unit.
3. Dispose of used batteries properly. Do not heat, disassemble,
or throw used batteries into a fire.
4. Keep the remote control away from areas where it may be
exposed to direct heat, moisture, or sunlight.