Filter
Top Products
-8-
SETTING THE CLOCK
1. Turn the radio on so that the radio frequency or clock time is shown on the display
panel.
2. Press and hold the Select button
3 approximately 4 seconds until the time display
begins flashing.
3. While the time display is still flashing, press the Manual Down Tuning button ( –)to
adjust the minutes and the Manual Up Tuning button ( +) to adjust the hours to the
correct time.
4. When the correct time is shown on the display panel, press the Select button
3 again
to return to the normal display.
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations
(10 KHz. channel spacing on AM, 200 KHz. spacing on FM). Use in other areas of the
world may require different channel spacing. A switch on the bottom of the chassis allows
selection of 9 KHz. AM/50 KHz. FM channel spacing. With the 16-pin power connector
un-plugged from the socket at the rear of the chassis, slide the switch to the appropriate
position using a small screwdriver blade.