Audiovox P-49 Stereo System User Manual


 
-7-
NOTE: Never leave a cassette engaged in the player when not in
use. Doing so can cause damage to the cassette and/or
mechanism of the unit. Always press the eject button and
remove the cassette when leaving the vehicle.
cq TIME/FREQUENCY (T/F) BUTTON
During radio operation, press this button to call the time display on
the incorporated quartz clock. The current time will appear together
with an A or P indication. The display will return to the radio frequency
indication after 5 seconds.
During cassette player operation, a second press of this button
will call the time display. During CD changer operation, the first
press of the button will call the time display. In either case, the
display will return to the disc or cassette indication after 5 seconds.
cr EQUALIZER BUTTON (EQ)
The EQ button applies preset sound effects to the unit’s audio output
signal. The EQ button, when pressed, will activate one of the following
operating modes: CLASSICS, POP, JAZZ, FLAT,or DSP OFF. When
the EQ function is active, as displayed on the panel, the bass and
treble levels cannot be changed. When the EQ function is not active,
the unit returns to the user set bass and treble levels. The FLAT
selection indicates no equalizer enhancement of the program, while
DSP OFF inhibits selection of equalizer mode enhancement.
cs PRE-SET SCAN (PS) / AUTO-STORE TUNING (AS)
Press this button momentarily to scan the stations pre-set into
each AM band and each FM band. The unit will stop at each pre-
set station for approximately 5 seconds before continuing to the
next pre-set station (the pre-set station number on the display
panel will flash during Pre-Set Scan operation). Press the button
again momentarily to stop Pre-Set Scan operation and remain on
the selected frequency. If no buttons are pressed during the scan,
the unit will continue to scan the band in use.
Pressing and holding the button for longer than 2 seconds will
activate the Auto-Store (AS) tuning feature which will automatically
scan and enter up to 6 local area stations into the pre-set memories
on the band in use. If you have already set the pre-set memories to
your favorite stations, activating the Auto-Store Tuning feature will
erase those stations and enter the new local ones. This feature is
most useful when traveling in a new area where you are not familiar
with the local stations.
ct THEFT-DETERRENT LED
Located on the chassis behind the front panel, a light-emitting diode
(LED) will flash when the panel is physically removed. The flashing
light serves as a visual warning to the would-be thief that the unit has
been disabled by removal of the front panel.
cu RESET BUTTON
The RESET button is located to the right of the theft deterrent LED.
The reset circuitry should only be activated under the following
circumstances as it will erase the time and pre-set memories:
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and return
to normal operation.