Filter
Top Products
128-6003A
8 of 20
button again or adjusting the AUDIO
CONTROL
2 level will return to the volume
level setting in use before the Mute function
was activated.
During disc play, pressing this button will
mute disc audio and disc play will be paused.
During this time, the
indication will remain
on the display panel to show that a disc is
still loaded in the unit.
bl AM/FM BAND SELECTOR (BAND)
Each time this button is pressed, the radio
band is changed. The indication AM, F1, F2
or F3 will appear on the display panel
according to your selection.
bm UP/DOWN TUNE/SEEK/TRACK
(
/ ) BUTTONS
To manually select a radio station,
momentarily press the Up Tuning (
)
button to tune the unit higher, or the Down
Tuning (
) button to tune lower within the
selected band. The radio will automatically
tune to the next strong station and stop on
this frequency. If the LOCAL mode is in effect,
the radio will seek the next local station and
stop at that frequency.
Pressing either button for longer than 2
seconds will cause MANUAL to appear on
the display, accompanied by a beep tone,
thereby entering the seek mode. Pressing a
button in this mode will cause the radio to
rapidly tune in the up or down direction and
stop when the button is released. The radio
will then remain at that frequency. Five
seconds after Manual tune is inactive, AUTO
will momentarily appear for 2 seconds,
thereby reverting to the normal tuning mode.
bn LOCAL BUTTON
This feature is used to select the strength of
the signals at which the radio will stop during
Manual Seek Tuning. Pressing and holding
the button will select the Local setting
(LOCAL will appear on the display panel for
5 seconds and LOC will remain in the lower
left corner) and only strong (local) stations
will be received. Pressing and holding the
button again will select the Distant setting
(Dx will appear on the display panel for 5
seconds) and the radio will stop at a wider
range of signals, including weaker (more
distant) stations.
bo FM MONO/STEREO BUTTON (MONO)
During FM radio operation, this button is
used to select monaural or stereo reception
of the broadcast signal. Under normal
reception conditions, the unit should be left
in the stereo mode as indicated by the ST
indication on the display panel when tuned
to an FM stereo signal. If the stereo signal
is too noisy for comfortable listening, press
the MONO button to switch to monaural
reception (the ST indication will disappear
from the display panel and MONO will
appear). To return to stereo reception mode,
press the button again so that the ST
indication appears on the display panel.
bp PRE-SET SCAN (PS)
AUTO-STORE TUNING (AS)
Press this button momentarily to scan the
stations pre-set into the six memories of the
current band in use. The unit will stop at each
pre-set station for 5 seconds before
continuing to the next pre-set station (the
pre-set frequency on the display panel will
flash during Pre-Set Scan operation). Press
the button again momentarily to stop Pre-
Set Scan operation and remain on the
77
77
7
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS