Filter
Top Products
10
WIRING THE FM MODULE
The FM module should be positioned near your existing car
stereo and the 15 foot data cable should be connected to it.
Make the following connections to the FM module:
15 FOOT DATA CABLE
"TO CD CHANGER"
LABEL
CAR FUSEBLOCK
ORANGE w/WHITE
STRIPE WIRE
15 FOOT EXTENSION LEAD
(MAY NOT BE REQUIRED)
SPLICE INTO "LIVE" WIRE
AND TAPE SPLICE
EXISTING +12 VOLT
"LIVE" WIRE
"RADIO" OR "ACCESSORY"
TERMINAL
FM MODULE
12 VOLT
CAR BATTERY
DATA CABLE
The 15 foot data cable connects the changer to the FM module.
First connect the end of the data cable labelled "TO CD
CHANGER" to the socket on the left side of the changer. Route
the other end of the cable up to the car’s dashboard area near
your existing car radio and plug the data cable into the mating
socket on the end of the FM module.
WIRING THE CD CHANGER
ORANGE WITH WHITE STRIPE WIRE
Attached to the FM module is a 3 foot orange with white
stripe wire. This is to be connected to a + 12 volt circuit that
is only live when the ignition is on. The best connection
point is at the car’s fuse block at the “RADIO” or “ACCES-
SORY” identified terminals.
GREEN WITH WHITE STRIPE
POWER WIRE
The 3 foot green with white stripe wire must be connected
toa “live” 12 volt wire in the vehicle. You will have to check
the wire you connect it to and make certain it is always “live”’
even when the car’s ignition is turned off. If none is found,
route the wire to the car’s fuseblock and connect it to a “live”
circuit there.
FM MODULE
FM MODULE
GREEN w/WHITE
STRIPE WIRE